Abstract:603 Objectives Digital Silicon Photomultiplier has recently emerged as a promising photodetector for ToF PET systems. It not only addresses a number of challenges encountered by analog SiPM such as power consumption and noise susceptibility, but also provides additional benefits including low cost and possibility to monolithically integrate the single-photon avalanche photodiode (SPAD) on the same substrate with complex circuitry[1-4]. In this study, a high-resolution, ultra-low power time-to-digital converter (TDC) was implemented to push the limit of timing resolution and improve image quality[5]. Methods Our SPAD array is fabricated in 130nm CMOS technology, using an n+/p-well junction[6]. A guard ring structure is formed to suppress the premature edge breakdown[7]. An improved passive-quenching, active-reset front-end circuit is coupled to each SPAD cell to disable noisy cells. Fig.1(a) shows the layout of our 8x8 SPAD array. Our TDC employs the Vernier Gated Ring Oscillator to improve the time resolution and reduces power consumption by a gated-mode operation. Fig.1(b) gives the TDC layout. Results The prototype chip is fabricated in standard 130nm CMOS, achieving 7.3ps resolution, 11ps precision, 1.2mW power consumption and 0.03mm2 area. A rms integral nonlinearity(INL) of 1.2LSB is obtained with the help of INL look-up-table calibration. Table I compares the performance with recent relevent works. Conclusions The design and characterization of a dSiPM prototype fabricated in a 130 nm standard CMOS is reported. It comprises of an 8x8 SPAD array and a high-resolution TDC, whose compact size makes it suitable for an array configuration. For the future work, the SPAD array and TDC will be coupled to scintillation crystals to evaluate energy resolution and time resolution for ToF PET imaging. Research Support The authors gratefully acknowledge support from the Canada Research Chair program, NSERC of Canada, CFI, FedDev Ontario, NSERC ResEau strategic network, NCE IC-IMPACTS and CMC Microsystems.

A Novel Ultra-High-Speed CMOS Image Sensor Implementation with Variable Spatial and Temporal Resolution using Temporal Pixel Multiplexing

A Multimodal Sensing CMOS Imager Based on Dual‐Focus Imaging(Adv. Sci. 14/2023)

A CMOS SPAD Sensor With a Multi-Event Folded Flash Time-to-Digital Converter for Ultra-Fast Optical Transient Capture

MEMS-based Two-Photon Microscopy with Lissajous Scanning and Image Reconstruction under a Feed-Forward Control Strategy.

High-speed optical imaging with sCMOS pixel reassignment

Analysis and Design of a CMOS Ultra-High-Speed Burst Mode Imager with In-Situ Storage Topology Featuring In-Pixel CDS Amplification

Serial time-encoded amplified imaging for real-time observation of fast dynamic phenomena

Super-Resolution Time-Resolved Imaging using Computational Sensor Fusion

A Single-Pixel Event Photoactive Device for Real-Time, In-Sensor Spatiotemporal Optical Information Processing

Pixel-wise programmability enables dynamic high-SNR cameras for high-speed microscopy

64 picosecond time resolved time-correlated single photon counting imaging

Principles and Applications of High-Speed Single-Pixel Imaging Technology.

CMOS pixel sensors optimized for large ionizing dynamic

Time-encoded single-pixel 3D imaging

High-speed Real-Time Single-Pixel Microscopy Based on Fourier Sampling

Development of a High Performance Digital Silicon Photomultiplier (dSiPM) for ToF PET Imaging

Sub-100 nanosecond temporally resolved imaging with the Medipix3 direct electron detector

Temporal multiplexing of the scientific grade camera for hyper-frame-rate imaging.

Time-gated SPAD camera with reconfigurable macropixels for LIDAR applications

Pixel multiplexing for high-speed multi-resolution fluorescence imaging

Single-Pixel Imaging in Space and Time with Optically-Modulated Free Electrons