Abstract:Nano-sized aluminum (Nano-Al) powders hold promise in enhancing the total energy of explosives and the metal acceleration ability at the same time. However, the near-detonation zone effects of reaction between Nano-Al with detonation products remain unclear. In this study, the overall reaction process of 170 nm Al with RDX explosive and its effect on detonation characteristics, detonation reaction zone, and the metal acceleration ability were comprehensively investigated through a variety of experiments such as the detonation velocity test, detonation pressure test, explosive/window interface velocity test and confined plate push test using high-resolution laser interferometry. Lithium fluoride (LiF), which has an inert behavior during the explosion, was used as a control to compare the contribution of the reaction of aluminum. A thermochemical approach that took into account the reactivity of aluminum and ensuing detonation products was adopted to calculate the additional energy release by afterburn. Combining the numerical simulations based on the calculated afterburn energy and experimental results, the parameters in the detonation equation of state describing the Nano-Al reaction characteristics were calibrated. This study found that when the 170 nm Al content is from 0% to 15%, every 5% increase of aluminum resulted in about a 1.3% decrease in detonation velocity. Manganin pressure gauge measurement showed no significant enhancement in detonation pressure. The detonation reaction time and reaction zone length of RDX/Al/wax/80/15/5 explosive is 64 ns and 0.47 mm, which is respectively 14% and 8% higher than that of RDX/wax/95/5 explosive (57 ns and 0.39 mm). Explosive/window interface velocity curves show that 170 nm Al mainly reacted with the RDX detonation products after the detonation front. For the recording time of about 10 μs throughout the plate push test duration, the maximum plate velocity and plate acceleration time accelerated by RDX/Al/wax/80/15/5 explosive is 12% and 2.9 μs higher than that of RDX/LiF/wax/80/15/5, respectively, indicating that the aluminum reaction energy significantly increased the metal acceleration time and ability of the explosive. Numerical simulations with JWLM explosive equation of state show that when the detonation products expanded to 2 times the initial volume, over 80% of the aluminum had reacted, implying very high reactivity. These results are significant in attaining a clear understanding of the reaction mechanism of Nano-Al in the development of aluminized explosives.

Laser ignition of energetic crystals of cyclotrimethylenetrinitramine (RDX) optically sensitized with gold nanoparticles and light-absorbing dye

Laser Initiation of RDX Crystal Slice under Ultraviolet and Near-Infrared Irradiations

Constructing hotspots through star-shaped gold-copper alloy nanocrystals for laser initiation of explosives

Constructing interparticle hotspots through cracking silver nanoplates for laser initiation of explosives

Shock Response of 1,3,5-Trinitroperhydro-1,3,5-triazine (RDX): the C-N Bond Scission Studied by Molecular Dynamics Simulations

Ultraviolet Laser-induced ignition of RDX single crystal

Electrostatic spraying synthesis of energetic RDX@NGEC nanocomposites

Simulation of the ignition of organic explosives by a laser pulse in the weak absorption region

Multi-scale modified nitramine crystals with conjugated structure intercalation and thin-layer catalyst coating for well-controlled energy release rate

Study on laser ignition characteristics of graphene Oxide/Cyclotrimethylene trinitramine composite films

Exposed Facets and Surface Properties of Highly Explosive RDX Studied by the Crystal-Face-Indexing Method and Theoretical Calculations

Poly(aluminum chloride) shell-desensitized cyclotrimethylenetrinitramine explosive core

Mechanochemical fabrication and properties of CL-20/RDX nano co/mixed crystals

Preparation and Characterization of Cyclotrimethylenetrinitramine (RDX) with Reduced Sensitivity

Preparation, High-Density Spherical, and Low Sensitivity of RDX/NC/PMMA Composite Particles

An exploration of anomalous electrical noise in shocked cyclotrimethylenetrinitramine (RDX)-based explosives

Electrospray Formation of RDX/ceria Mixture and Its Thermal Decomposition Performance

Reactive simulation of the chemistry behind the condensed-phase ignition of RDX from hot spots

Sensitizing Explosives Through Molecular Doping

Effects of nano-sized aluminum on detonation characteristics and metal acceleration for RDX-based aluminized explosive

Insensitive energetic microspheres DAAF/RDX fabricated by facile molecular self-assembly