Abstract:Hydraulic fracturing techniques are often applied to form permeability enhancement zones near boreholes and/or wellbores in tight low-permeability reservoirs to improve their extraction efficiency. As conventional hydraulic fracturing techniques often generate high breakdown pressure and induced seismic potential, novel alternative production enhancement techniques (such as pulse hydraulic pressurization) have been proposed. However, their applicability requires further verification. Therefore, this study conducted hydraulic fracturing tests of coal under three test schemes: conventional hydraulic fracturing (CHF), stepwise pressurization hydraulic fracturing (SPHF), and stepwise pulse pressurization hydraulic fracturing (SPPHF), considering the true triaxial stress state of an actual coal seam. The results showed that the breakdown pressure of coal decreased with an increase in the horizontal stress difference ( σ 2 - σ 3 ). Moreover, the pulse pressurization produced more intergranular fractures and caused a large number of particles to be conducted as a stress concentrator at the fracture tip spalling, which promoted the unstable propagation of fractures, which decreased the breakdown pressure of coal. The abnormally high breakdown pressure in the SPHF experiments is likely due to the obstruction of high σ 2 to the fracture propagation rate and fluid injection, which intensifies the fluid hysteresis effect and the stable fracture development and expansion during the pressure-maintaining stage, thus increasing the breakdown pressure. To describe the relationship between the variation in the breakdown pressure and fracture evolution characteristics, we introduced the equivalent characteristic length l and established a breakdown pressure prediction model based on the tensile stress criterion, which shows effective prediction of the breakdown pressure in different test schemes. Anisotropic principal strain appeared under different injection schemes. During the CHF and SPHF experiments, fluid injection deformed the σ 1 direction by compression and the σ 3 direction by expansion. In the σ 2 direction, the deformation transitioned from expansion at a low stress level to compression at a high stress level. The deformation in the σ 2 direction was always compressive in the SPPHF experiments. Continuous and pulse pressurizations can promote the deformation and fracture development. For the fracture morphology, the coal in the CHF experiments was dominated by a single tensile fracture, and macroscopic shear fractures were formed in the SPHF and SPPHF experiments owing to the continuous stimulation of fluid pressure to the bonding of particles and the weak surface structure, such as bedding and cleats during the pressure maintenance and pulse, and the fragmentation effect was significant and accompanied by obvious particle spalling.

Dynamic mechanical responses and crack evolution of burst-prone coal with a single prefabricated fissure

Burst Failure Characteristics and Energy Evolution Law of Coal with Prefabricated Cracks at Different Angles

Discrete element study on mesomechanical behavior of crack propagation in coal samples with two prefabricated fissures under biaxial compression

Dynamic mechanical response and crack evolution law of raw coal loaded by dynamic-static coupling under three-dimensional constraints

Investigation of dynamic fracture behavior and energy dissipation of water-bearing coal under impact load

Fracture features of brittle coal under uniaxial and cyclic compression loads

Research on the dynamic tensile characteristics and surface crack evolution of coal under impact loading

Research on the Energy Dissipation Patterns and Fragment Size Distribution Characteristics of Coal Under Cyclic Impact Loading With Confining Pressure

Experimental study on deformation and fracture characteristics of coal under different true triaxial hydraulic fracture schemes

Mechanical properties and energy evolutions of burst-prone coal samples with holes and fillings

Experimental Study on the Damage Evolution Behavior of Coal Under Dynamic Brazilian Splitting Tests Based on the Split Hopkinson Pressure Bar and the Digital Image Correlation

Failure characteristics and meso-deterioration mechanism of pre-stressed coal subjected to different dynamic loads

Microcracking Characterization in Tensile Failure of Hard Coal: An Experimental and Numerical Approach

Failure characteristics and mechanism of coal under the coupling between different confining pressures and disturbance loading

Characteristics of Pore and Fracture of Coal with Bursting Proneness Based on DIC and Fractal Theory

Crack Propagation and AE/EMR Response Characteristics of Pre-Holed Coal Specimens under Uniaxial Compression

Crack Damage Propagation and Morphology Distribution of Hydraulic Electric Pulse Fractured Coal

Experimental Study on the Dynamic Tensile Characteristics of Coal Samples

Mechanical behavior and reloading reinforcement characteristics of fractured coal under low confining pressure

Dynamic tensile behaviour and crack propagation of coal under coupled static-dynamic loading

Fracture propagation and pore pressure evolution characteristics induced by hydraulic and pneumatic fracturing of coal