Abstract:The heat transfer and flow of nanofluids in microchannel heat sink is usually numerically investigated by the single-phase model. The thermal conductivity and viscosity of nanofluids are calculated in the whole computational region because the single-phase model, assumes the nanofluids is static and nanoparticles concentration is uniform. However for the actual forced flow process, the concentration distribution of the nanofluids is not uniform. So the thermal properties of the nanofluids vary within different computational regions. With the increase of the velocity of the nanofluids, the deviation between the prediction of single-phase model and experimental results increases. In this paper, a new simulation method is proposed to consider the inhomogeneous and dynamic thermophysical properties of the nanofluids by obtaining the nonuniformly distributed nanoparticle concentration in each numerical cell. At the same time, it takes into account the following factors: the interactions between the nanoparticles, the solid wall and the base fluid, the axial conduction, the slip boundary conditions and fluid-solid coupling. The results show that the proposed numerical simulation method further improve the simulation accuracy for the forced flow and heat transfer process of nanofluids in the microchannel in a wider range. The effects of the nanoparticles concentration, Reynolds number and axial heat transfer on the thermophysical properties of the nanofluilds, the flow and heat transfer characteristics of a rectangular microchannels with hydraulic dimensions of 341μm were analyzed using the proposed simulation model. The main results are as follows: the nanoparticles are enriched at the near wall for the fully developed region; the nonuniformity of the nanofluilds thermal conductivity coefficient distribution at the channel cross section increases with the increase of the mass flow rate and the inlet centration; under the same Reynolds number, the higher the nanofluids concentration the better the heat transfer characteristics, but there is no linear relationship between the enhancement amplitude and concentration; the heat transfer coefficient of nanofluid with 1% and 2% alumina nanoparticles concentration is about 5.86% and 8.49% higher than that of deionized water, respectively; the axial conduction effect cannot be ignored for the microchannel, which significantly affects the inlet and outlet region of the microchannel especially when the Reynolds number is low. The nanofluilds temperature in the microchannel increases with the curve and does not match the conventional linear growth hypothesis.

Investigation of unsteady nanofluid over half infinite domain under the action of parametric effects and EPNM

Thermal study of single phase nanofluid model using radiative γAl2O3 nanomaterial under Hall current and momentum slip phenomena

Concentration-dependent electrical and thermal conductivity effects on magnetoHydrodynamic Prandtl nanofluid in a divergent–convergent channel: Drug system applications

Investigations of nanofluid flow and heat transfer in a rotating microchannel using single- and two-phase approaches

Numerical Investigation of Laminar Convective Heat Transfer and Pressure Drop of Water-Based Al 2 O 3 Nanofluids in a Microchannel

A Dissipative Particle Dynamics Two-Component Nanofluid Heat Transfer Model: Application to Natural Convection

Dynamics of nanoparticle diameter and solid–liquid interfacial layer on the Al2O3–H2O nanofluid flow over a uni-directional extending heated surface: a numerical analysis

Numerical Study of Flow and Heat Transfer Characteristics for Al2O3 Nanofluid in a Double-Pipe Helical Coil Heat Exchanger

Dynamics of non-newtonian methanol conveying aluminium alloy over a rotating disc: consideration of variable nanoparticle radius and inter-particle spacing

Numerical study of heat transfer and friction drag in MHD viscous flow of a nanofluid subject to the curved surface

Exploration of entropy analysis and viscous dissipation on radially convective flow of (Cu‐Al2O3:H2O) hybrid nanofluid over a stretching disk

Impacts of nanoscaled metallic particles on the dynamics of ternary Newtonian nanofluid laminar flow through convectively heated and radiated surface

Numerical Analysis of MHD Nanofluid Flow Characteristics with Heat and Mass Transfer over a Vertical Cone Subjected to Thermal Radiations and Chemical Reaction

Modeling of nanofluid thermophysical treatment through a permeable container under the impact of MHD

Numerical analysis of heat transfer and friction drag relating to the effect of Joule heating, viscous dissipation and heat generation/absorption in aligned MHD slip flow of a nanofluid

Investigating the influence of temperature-dependent rheological properties on nanofluid behavior in heat transfer

Numerically analyzed of ternary hybrid nanofluids flow of heat and mass transfer subject to various shapes and size factors in two-dimensional rotating porous channel

Investigation of forced convection of a novel hybrid nanofluid containing NEPCM in a square microchannel: Application of single-phase and Eulerian-Eulerian two-phase models

Numerical aggregation for dissipative flow of hybrid nanomaterial: Darcy Forchheimer model

Numerical Investigation of Nanofluid Convection Performance in the Fully Developed Flow Regime of the Pipe with Constant Wall Temperature

Modeling of thermal and solute transport within a Maxwell fluid in contact with a porous rotating disc