Fluoride sorption from aqueous solution using Al(OH)3-modified hydroxyapatite nanosheet

Shaomeng Huang,Minglei Hu,Dan Li,Liping Wang,Can Zhang,Kang Li,Qiongqiong He
DOI: https://doi.org/10.1016/j.fuel.2020.118486
IF: 7.4
2020-11-01
Fuel
Abstract:<p>In this study, Al(OH)<sub>3</sub>-hydroxyapatite nanosheet (Al(OH)<sub>3</sub>-nHAP), an adsorbent of high defluoridation capacity, was prepared based on the nano hydroxyapatite (nHAP) with lattice defect (4% calcium deficiency) brought by the addition of EDTA. And the composite was characterized by XRD, TEM-EDS, FT-IR and N<sub>2</sub> adsorption method. The effects of adsorbent dosage, pH value, initial fluoride concentration and co-existing ions to the adsorption behaviors were studied, and then kinetics, isotherms, thermodynamics, ion exchange rate, regeneration and dissolution were investigated. The maximum defluoridation capacity of Al(OH)<sub>3</sub>-nHAP nanosheet were 141.84, 171.88 and 194.2 mg/g at 298, 308 and 318 K in neutral condition with the initial fluoride concentration of 200 mg/L. The high defluoridation capacity was due to the high Al/Ca atomic ratio (1.44). The nHAP with lattice defect might help Al atoms to dope into the nHAP. About 22.14% of Al atoms was doped into the lattice of nHAP and 77.86% was loaded on the surface of nHAP by modifying. Ca<sub>9.6</sub>(PO<sub>4</sub>)<sub>6</sub>(OH)<sub>1.2</sub> and 8.5156Al(OH)<sub>3</sub>-Ca<sub>7.5792</sub>Al<sub>2.4208</sub>(PO<sub>4</sub>)<sub>6</sub>(OH)<sub>4.4208</sub> was proposed as the chemical formula of nHAP and Al(OH)<sub>3</sub>-nHAP synthesized in this study via calculations. The adsorption performance followed the Pseudo-second-order kinetic model and Freundlich isotherm model, which was a spontaneous and endothermic process. The removal efficiency of regenerated Al(OH)<sub>3</sub>-nHAP nanosheet always stayed above 81.32% and showed good stability during the four cycles. The concentrations of Al<sup>3+</sup>, Ca<sup>2+</sup> and F<sup>−</sup> in dissolution experiment were 0.01, 2.11 and 0.56 mg/L, respectively, indicating its safety and stability.</p>
energy & fuels,engineering, chemical
What problem does this paper attempt to address?