Abstract:Diffusers are devices found in several engineering applications and their performance and design are object of numerous investigations. However, relatively few investigations have been dedicated to diffusers operating at low and moderate Reynolds numbers. In this regime, the flow could be laminar, turbulent or transitional, and the aerodynamic performance of the diffuser becomes highly dependent on the specific value of the Reynolds number and inlet conditions. In particular, the present study focuses on evaluating the role of inlet conditions on the performance and flow behaviour of two-dimensional diffusers on this specific Reynolds number regime ( ). Furthermore, the diffuser discharges in a stationary chamber and it does not present a tail-pipe configuration, a condition that has not found a clear presence in the existing literature so far. A numerical investigation of two-dimensional plane diffusers was performed at for 9 different cases, combined varying the inlet turbulence intensity (0.05, 3, and 10 percent), and the velocity profile, characterised by different blockage factors (0, 0.05 and 0.33). For each case, the divergence angle ranged from 0 to 30 degrees, and several URANS simulations were performed using the Transitional SST model that accounts for the possible transition of the boundary layer. The results show that the design recommendations valid for high Reynolds number diffusers with a thin boundary layer are not always applicable, and extreme caution must be exercised when dealing with operating conditions that do not ensure a sufficiently high turbulence level at the inlet. The divergence angles of the stall regimes are shown, and performance indicators (e.g. pressure-recovery coefficients) are reported. These reveal a strong decrement (up to 60 percent) of the pressure recovery on reducing turbulence intensity from 10 percent to 0.05 percent. The blockage factor of the velocity profile has an important effect on performance as well. In order to simplify the comparison between the different blockage factors, a modified effectiveness was employed to account for the distortion introduced by a non-uniform inlet velocity profile.

Building integrated diffusers' area ratio optimization

Experimental analysis and design optimization of an empty diffuser for performance Enhancement in DAWT

Effect of Tip Clearance on the Heat Transfer and Pressure Drop Performance in the Micro-Reactor with Micro-Pin–fin Arrays at Low Reynolds Number

Performance Analysis of Two-Dimensional Plane Diffusers at a Moderate Reynolds Number by Means of Unsteady RANS

A simplified approach to describe complex diffusers in displacement ventilation for CFD simulations

The Influence of Two Different Dihedral Angles on Diffuser Performance Based on LES

FLOW PERFORMANCE COMPARISON ALONG THE CENTERLINE IN STRAIGHT AND S-SHAPED DIFFUSER

Automated shape optimisation of a plane asymmetric diffuser using combined Computational Fluid Dynamic simulations and multi-objective Bayesian methodology

Modelling the link amongst fine-pore diffuser fouling, oxygen transfer efficiency, and aeration energy intensity

INVESTIGATION OF THE MAP WIDTH IMPROVEMENT IN A RADIALLY REDUCED DIFFUSER DESIGN CONCEPT FOR A CENTRIFUGAL COMPRESSOR

Detached Eddy Simulation and PIV Validation of the Flow in a Compact Return Diffuser

A Numerical Study On The Flow Mechanism Of Performance Improvement Of A Wide-Angle Diffuser By Inserting A Short Splitter Vane

Effect of Space Diffuser on Flow Characteristics of a Centrifugal Pump by Computational Fluid Dynamic Analysis

[Study on Energy Dissipation in Modified Airlift Bioreactor].

Air Supply Opening Model of Ceiling Diffusers for Numerical Simulation of Indoor Air Distribution under Actual Connected Conditions, Part II: Application of the Model

Study of Influence of Boundary Condition of Diffuser with Non-Uniform Velocity on the Jet Characteristics and Indoor Flow Field

Aerodynamic Design and Performance Evaluation of Pipe Diffuser for Centrifugal Compressor of Micro Gas Turbine

Experimental and large-eddy simulation study of swirling air jet: Application for the improvement of the spatial temperature homogeneity

Investigation Of Vaned Diffuser Splitters On The Performance And Flow Control Of High Pressure Ratio Centrifugal Compressors

Of vaned diffuser splitters on the performance of a and flow control high pressure ratio centrifugal compressor

Design and flow analysis of variable geometry wedge diffuser