Abstract:International Journal of Modern Physics C, Ahead of Print. The objective of this study is to investigate the impact of different surface roughness levels on a staggered arrangement of tubes in a cross-flow configuration, with water as the fluid being used. The focus lies in comparing the data obtained from the rough surface configuration with that of a smooth cylinder reference point. To assist this comparison, a comprehensive two-dimensional computational fluid dynamics (CFD) model is created, which accurately represents the distinctive characteristics of each surface shape. This study also included modifying the Remax within a range of 10 000–16 000 and analyzing the outcomes of using four different tube types, each with different supernatant thicknesses labeled as [math], [math], [math] and [math] accordingly. Surprisingly, the tube with a 0.4 wave surface had significantly higher average Nusselt numbers (Nu) compared to the other tubes, indicating superior performance. The ideal tube design was found based on three main metrics: The performance evaluation criterion (PEC), the global performance criterion (GPC) and the average Nu. The performance metrics encompassed the PEC, GPC and the Colburn factor [math]. The average Nu of the wavy_0.4 tube was higher than that of the SM by 31.66–32.54%, higher than that of the wavy_0.2 tube by 19.76–20.74%, and higher than that of the wavy_0.1 tube by 9.38–16.58%. According to the statistics, a heat exchanger that cools and has a wave with an amplitude of 0 is the most efficient choice for offshore energy systems. The smooth bundle tube (SBT) demonstrated the most significant increase in GPC, with values of 9.3–12.7% and 20.3–28.3% higher than those of wavy tubes with amplitudes of 0.1 and 0.2, respectively. In addition, correlations for the Nu are given, with results verified using empirical data from Balabani et al.

Ammonia condensation experiments at Oak Ridge National Laboratory

Experimental study of ammonia condensation on vertical fluted tubes. [For OTEC plants]

Experimental Study of Ammonia Flow Boiling in a Vertical Tube Bundle: Part 4 – Comparative Analysis

Experimental Study of Ammonia Flow Boiling in a Vertical Tube Bundle: Part 1 – Enhanced Dimple Tube

Experimental study of ammonia flow boiling in a vertical tube bundle: Part 2-Enhanced dimple tube with full length solid round PVC nonconductive rod

Three-dimensional Numerical Study on Finned Reactor Configurations for Ammonia Thermochemical Sorption Energy Storage

Condensation Heat Transfer on the Outer Surface of a Horizontal Annulus Having Surface Enhancement

Investigation of the effects surface alteration via coatings on the condensation heat transfer and wettability

Development of tin copper alloys in shell and tube evaporator heat exchanger systems in ocean thermal energy converse power plant

Experimental Study on Condensation in the Outer Annular Region Outside Horizontal Enhanced Tubes

Experimental Investigation of Shell-Side Flow Condensation on Three-Dimensional Enhanced Surface Tubes

Experimental Investigation of Thermal Performance of a Novel Alternating Cross-Section Flattened Tube Heat Exchanger

Ammonia flow boiling in the smooth, annuli and inner-finned tube at different gravity orientation

An Experimental Study of In-Tube Condensation and Evaporation Using Enhanced Heat Transfer (EHT) Tubes

Performance of a Novel Single-Tubular Ammonia-Based Reactor Driven by Concentrated Solar Power

Prediction of Heat Transfer During Condensation of Ammonia Inside Tubes and Annuli

Performance of Conical Ammonia Dissociation Reactors for Solar Thermochemical Energy Storage

Numerical study of the influence of amplitudes on heat transfer in a tube bundle

Heat transfer performance evaluation of an evaporator-condenser for hybrid cycle OTEC

Experimental investigation of a novel heat exchanger for optimizing heat transfer performance using Al2O3-water nanofluids

Shell Side Direct Expansion Evaporation of Ammonia on a 3-D Structured Surface Tube Bundle with Exit Superheat Effect