Abstract:Layered structures comprising coral sand and gravel have been observed in hydraulic filled foundations in the coral reefs in the South China Sea, leading to anisotropy in their physical and mechanical properties. However, the effect of a layered structure on the strength and deformation of the coral soil foundation remains unclear. In this study, a series of large-scale triaxial compression tests and step-loading tests were carried out on four types of samples, i.e., clean coral sand, clean coral gravel, sand-over-gravel layered sample, and gravel-over-sand layered sample, to investigate the impact of confining pressure and the layered structure on the strength and failure modes of these soils. The results indicate that the stress–strain relationships of all samples predominantly exhibit strain hardening under drained conditions. Under identical confining pressures, the peak strength of clean coral sand is the lowest, while that of coral gravel is the highest. The peak strengths of the two layered samples fall between these extremes, with the gravel-over-sand layered sample exhibiting higher strength. All four samples have similar peak friction angles, slightly exceeding 40°. The difference in peak strength among the four types of samples is attributed to the variations in cohesion, with the cohesion of clean coral gravel being up to four times that of clean sand, and the cohesion of layered samples falling between these two. Both clean sand and clean gravel samples exhibit a bulging phenomenon in the middle, while the layered samples primarily exhibit bulging near the coral gravel layer. In the step-loading tests, the bearing capacity of the layered samples falls between those of clean coral sand and coral gravel, with the gravel-over-sand layered samples demonstrating higher strength. Moreover, the p-s curve of the gravel-over-sand layered samples obtained from the large-scale triaxial apparatus under a confining pressure of 400 kPa resembles that from the plate load tests on the same samples.

Strength and dilatancy of coral sand in the South China Sea

Stress-dilatancy behavior of marine coral sand incorporating non-plastic fines

Experiment of initial relative density effects on sand strength

Shear Strength and Dilatancy of Calcareous Sand in the South China Sea

Shear strength-dilation characteristics of coral sand contained fines

Particle size and confining-pressure effects of shear characteristics of coral sand: an experimental study

Drained shear behavior of coral sand-diatom mixtures

Micro-and macro-mechanical behavior of crushable calcareous sand in South China Sea

Effects of Size and Shape on the Crushing Strength of Coral Sand Particles under Diametral Compression Test

Experimental Study of Dynamic Shear Modulus and Damping Ratio Characteristics of Coral Sand from Nansha Islands

Experiment Study on the Influence of Density and Confining Pressure on Triaxial Shear Properties of Calcareous Sand

Dilatancy behaviors of calcareous sand considering particle breakage

Experimental Study on the Mechanical Strength, Deformation Behavior and Infiltration Characteristics of Coral Sand

Large-Scale Triaxial Test on Mechanical Behavior of Coral Sand Gravel Layered Samples

Experimental study of one-dimensional compression creep in crushed dry coral sand

Effect of Relative Density on the Mechanical Behavior of Coral Sand Under High Strain Rate

Study of Dilatancy Behaviors of Calcareous Soils in a Triaxial Test

The Undrained Shear Behavior of Clean Coral Silt and Coral Silt-Sand Mixtures

Effects Of Cyclic Loading Directions On Liquefaction Characteristics Of Saturated Coral Sand

Experimental Investigation of Cyclic Failure Mechanism of Saturated Coral Sand under Various Consolidation Conditions

Effect of High-Stress Levels on the Shear Behavior of Geosynthetic-Reinforced Marine Coral Sands