Analytical Py-GC/MS study on conversion behaviors and reaction mechanism of biochar-mediated catalytic upgradation of primary pyrolytic products from lignocellulosic biomass
Linzheng Wang,Ruizhi Zhang,Nachuan Li,Yubing Lu,Zhengqi Sun,Shaozhuo Niu,Yonghao Luo
DOI: https://doi.org/10.1016/j.fuel.2023.130673
IF: 7.4
2024-01-05
Fuel
Abstract:This study aims to demonstrate the general carbocatalytic conversion behaviors and reaction mechanisms of representative biomass-derived primary pyrolytic products towards product upgradation. Specifically, 4-Ethylguaiacol (4-EGC) and 5-hydroxymethylfurfural (5-HMF) were selected as lignin- and cellulose/hemicellulose-derived model compound, respectively, to elucidate the origin of products under different temperatures and biochar-reactant mixing ratios. Three reaction routes were distinguished, including side-chain elimination, ring opening and recombination, with each route exhibiting unique characteristics in terms of initiation temperature and selectivity. For 4-EGC, elimination of side-chains began at 500 °C, accompanied by alkyl transfer reactions to generate multi-alkyl-substituted phenols, while ring-opening started at 700 °C, and aromatics could be simultaneously produced. Biochar did not change the initiation temperature of each route but significantly influenced the product distribution. Comparing the biochar-reactant mixing ratio of 0 and 10:1, at 600 °C the selectivity towards phenols increased from 20.52 % to 54.98 %, and at 800 °C the selectivity towards aromatics increased from 14.28 % to 53.01 %. For 5-HMF, the elimination of side chains already began at 400 °C, and the ring-opening started at around 600 °C, but recombination products (phenols and aromatics) would not notably emerge until 700 °C. Biochar could both lower the initiation temperature of each reaction route and change the conversion efficiency for 5-HMF owing to the lower stability of furan ring. However, the impact of biochar on selectivity towards aromatics was less pronounced compared to 4-EGC. Even at 800 °C, the relative content of aromatics only reached 28.88 % with a biochar-reactant mixing ratio of 10:1 for 5-HMF. Comparative investigations on biochar structure before and after co-pyrolysis reactions further revealed that, at 600 °C, biochar maintained its structural integrity, but at 800 °C, it underwent significant changes, including amorphous carbon deposition covering the surface. Raman spectra analysis supported these findings, showing that biochar becomes more amorphous after reactions at 600 °C, while at 800 °C, larger aromatic ring systems form on the biochar, reducing defect sites.
energy & fuels,engineering, chemical