Abstract:A rotating body consisting of a rotating shaft and bearings inevitably generates voltage and current. The potential difference between the bearing and the shaft is the main cause of electrical corrosion, which causes motor failure, shortened bearing life, and many safety issues. To prevent corrosion, passive shaft-grounding devices use conductive materials and brushes; however, these devices cannot be completely grounded, so there is a difference in local potential, and brush friction generates a shaft current. The cumulative effect causes electrical corrosion; therefore, in this study, an electrical corrosion protection device for the rotating power supply shaft was developed. It detected current and potential difference and established a feedback system on the rotating shaft. It also energized the rotating shaft using an external power supply to eliminate the potential difference on the shaft and reduce electrical corrosion. The result was prolonged motor life and improved stability, operating efficiency, and operability of related equipment. In this study, a rotating-shaft test rig was set up, and a constant current was applied to simulate the potential difference and verify the performance of the anti-corrosion device. Gradually, the design scheme was optimized; the potential difference on the rotating shaft was accurately quantified; and the goal of controlling the potential difference within 2 mV was achieved. Finally, the electrical corrosion protection device was applied to the rotating shaft of a merchant ship, and the current and potential difference on the rotating shaft were monitored for 30 days. The results showed that the device had excellent performance in reducing the potential difference on the rotating shaft and preventing electrical corrosion.

Experimental Study on the Electrical Performance of an Automotive Actuator DC Motor According to Brush Surface States

Analysis of Armature Circuit of the New DCM

Steady Performance Analysis on Single-Phase Brushless DC Motor

Study on Reducing Dead Area of the Brushless Direct Current Motor

Performance Calculation of Brushless Dc Motor

Comparative Performance Evaluation of Hall Effect Sensorless Control Options in Permanent Magnet Brushless DC Motor Drives

Experimental Investigation on Friction Characteristics of Ultrasonic Motor

Commutation Study of DC Motor for Automotive Fuel Pumps

Effect of Electrical Current on the Tribological Property of Cu-Graphite Brush

Study on Electrical Pitting Prevention Device of a Rotating Shaft Using Automatic Control Potential Balancing

Study of Armature Equivalent Resistance in Brushless DC Motor

Characterization of Small DC Brushed and Brushless Motors

Closing action characteristics of the electromagnetic mechanism of the parallel double coil type DC contactor

A Comparison of Different Types of Motors Used for Low Speed Electric Vehicles: Experiments and Simulations

Study the influence of power-current impact with different conditions on the current-carrying wear property of carbon brush/friction disc contact

Parameters And Performances Test Of Dc Motor With No-Loading Method

Comparisons Of Electric Machines Used For The Electro-Mechanical Actuation Systems In All-Electric Airplane

A Multi-Point Contact Model Considering Rough Surface for Linear Ultrasonic Motors: Validation and Simulation

Condition monitoring of a surface mounted permanent magnet‐type brushless direct current motor using remodelling of rotor magnetic field and stator winding inductance

A Study on Optimization of Noise Reduction of Powered Vehicle Seat Movement Using Brushless Direct-Current Motor

Increasing the Efficiency of Diagnostics in the Brush-Commutator Assembly of a Direct Current Electric Motor