Abstract:This paper is the second in a set of two investigating tilt-to-length (TTL) coupling. TTL describes the cross-coupling of angular or translational jitter into an interferometric phase signal and is an important noise source in precision interferometers, including space gravitational wave detectors like LISA. We discussed in <a class="link-https link-external" data-doi="10.1088/2040-8986/ac675e" href="https://doi.org/10.1088/2040-8986/ac675e" rel="external noopener nofollow">https://doi.org/10.1088/2040-8986/ac675e</a> the TTL coupling effects originating from optical path length changes, i.e. geometric TTL coupling. Within this work, we focus on the wavefront and detector geometry dependent TTL coupling, called non-geometric TTL coupling, in the case of two interfering fundamental Gaussian beams. We characterise the coupling originating from the properties of the interfering beams, i.e. their absolute and relative angle at the detector, their relative offset and the individual beam parameters. Furthermore, we discuss the dependency of the TTL coupling on the geometry of the detecting photodiode. Wherever possible, we provide analytical expressions for the expected TTL coupling effects. We investigate the non-geometric coupling effects originating from beam walk due to the angular or translational jitter of a mirror or a receiving system. These effects are directly compared with the corresponding detected optical path length changes in <a class="link-https link-external" data-doi="10.1088/2040-8986/ac675e" href="https://doi.org/10.1088/2040-8986/ac675e" rel="external noopener nofollow">https://doi.org/10.1088/2040-8986/ac675e</a>. Both together provide the total interferometric readout. We discuss in which cases the geometric and non-geometric TTL effects cancel one-another. Additionally, we list linear TTL contributions that can be used to counteract other TTL effects. Altogether, our results provide key knowledge to minimise the total TTL coupling noise in experiments by design or realignment.

Compact advanced pure tilt actuator for testing tilt-to-length coupling in space-based gravitational wave detection

Advanced pure tilt actuator for testing tilt-to-length coupling in space-based gravitational wave detection

Tilt-to-length coupling noise suppression based on transformation of q parameters of Gaussian beams in spaceborne gravitational wave detection

Experiment demonstration of tilt-to-length coupling suppression by beam-alignment-mechanism

Research on the tilt-to-length Coupling Noise Suppression Method inside the Gravitational Wave Detection Telescope

The impact of telescope aberrations on the magnitude of tilt to length coupling noise in space based gravitational wave detectors

Tilt-to-Length Coupling Analysis of an Off-Axis Optical Bench Design for NGGM

Non-geometric tilt-to-length coupling in precision interferometry: mechanisms and analytical descriptions

Tilt-To-Length Coupling in LISA -- Uncertainty and Biases

Geometric tilt-to-length coupling in precision interferometry: mechanisms and analytical descriptions

Postprocessing of tilt-to-length noise with coefficient drifts in TianQin using a null time-delay interferometry channel

In-Depth Modeling of Tilt-To-Length Coupling in LISA's Interferometers and TDI Michelson Observables

Approximate model for the coupling of far-field wavefront errors and jitter in space-based gravitational wave laser interferometry

Design of Dedicated Tilt-to-Length Calibration Maneuvers for LISA

On point-ahead angle control strategies for TianQin

Verification of Laser Heterodyne Interferometric Bench for Chinese Spaceborne Gravitational Wave Detection Missions

Compact active vibration isolation and tilt stabilization for a portable high-precision atomic gravimeter

A single Quasi-cubic Test Mass Configuration for Space-based Gravitational Wave Detection

High-bandwidth tilt-tip mirror with octagonal prism flexible mechanism

Effect of the focusing system on measurements in gravitational wave detection telescope