Assessment of Residual Stress Behavior and Material Properties in Steels Produced via Oxynitrocarburized Metal Injection Molding

Jorge Luis Braz Medeiros,Luciano Volcanoglo Biehl,Carlos Otávio Damas Martins,Diego Augusto de Jesus Pacheco,José de Souza,Afonso Reguly
DOI: https://doi.org/10.1007/s11665-024-09401-x
IF: 2.3
2024-04-02
Journal of Materials Engineering and Performance
Abstract:By combining the formability of injection-molded polymers with a wide range of metal options, metal injection molding (MIM) allows for manufacturing metallic components with small dimensions and complex geometries. However, steels produced through this process often exhibit higher porosity compared to conventional methods. This article aims to fill this gap by developing a thermochemical oxynitrocarburizing treatment cycle applied to the austenitic stainless steel Catamold 316L. The developed treatment analyzes the diffusion kinetics, mechanical properties, and metallurgical behavior. The oxynitrocarburizing treatment was carried out at a temperature of 570 °C for varying durations of 30, 60, and 120 min. The findings showed that surface microhardness significantly increased, and corrosion resistance improved due to the ceramic behavior of the Epsolon composite and the formation of magnetite, compared to the sintered material. The study reveals a substantial rise in residual compressive stresses of up to − 2790 MPa on the sample surface. The residual stress values and the elevated surface microhardness are highly beneficial for improving the tribological properties of Catamold 316L steel produced by the MIM process. The study suggests that using ionic oxynitrocarburizing in salt baths presents an alternative to plasma processes for treating Catamold 316L steel, providing improved diffusion of nitrogen and carbon.
materials science, multidisciplinary
What problem does this paper attempt to address?