Abstract:In the LAMOST project. the unit-holes on the Focal Plane Plate are the final installation location of the optical fiber positioning system. Theirs precision will influence the observation efficiency of the LAMOST. For the unique requirements, the Unit-holes on the Focal Plane Plate are composed by a series of tiny angle dimensional holes which dimensional angle are between 16' to 2.5 degrees. According to these requirements, the measurement of the tiny angle dimensional holes for the unit-holes needs to less than 3'. And all the unit-holes point to the virtual sphere center of the Focal Plane Plate. To that end, the angle departure Of the Unit-holes axis is changed to the distance from the virtual sphere center of Focal Plane Plate to the unit-holes axis. That is the better way to evaluate the technical requirements of the dimensional angle errors. In the measuring process, common measuring methods do not fit for the tiny angle dimensional hole by CMM(coordinate measurement machine). An extraordinary way to solve this problem is to insert a measuring stick into a unit-hole, with a target ball oil the stick Then measure the low point of the ball center and pull Out the stick for the high station of center. Finally, calculate the two points for the unit-hole axis to get the angle departure. But on the other hand, use this methods will bring extra errors for the measuring stick and the target ball. For better analysis this question, a series experiments are mentioned in this paper, which testify that the Influence of the measure implement is little. With increasing the distance between the low point and the high point position in the measuring process should enhance the accuracy of dimensional angle measurement.

Measuring tool used for measuring locating hole distance

Non-vertical end face hole depth measuring tool

Three-Dimensional Measurement System for Inner Surface of Long Tubular Parts Based on White Light Interference

An Improved Two-Point Real-Time Measuring Method for Radial Micro-Displacement Measurement on High-Speed Smart Boring Bar

Machining Precision Online Measurement of Large Span Pin Hole Using Structured Light

Real-time Measuring Method to Measure the Micro-Displacement of a Rotating Cutter in Precise Piston Noncylinder Pinhole Boring

Device for measuring inlay distance from inlay jump-ring slot to cylinder hole bottom of car

Development of Non-Contact Automatic Thread Measuring Instrument

An optical-based measurement method for center distance between two double-hole components

Device and method of measuring shield tunnel segment dislocation

Embedded displacement measuring device based on error separating technique of multi-circle overlapping three-probe method

Hole Depth Measuring Device based on Mechanical Wave Reflection

Porous tooth hub hole position testing fixture

A Laser Triangulation-based 3D Measurement System for Inner Surface of Deep Holes

High Precise Measurement of Tiny Angle Dimensional Holes for the Unit-Holes of the LAMOST Focal Plane Plate

Simple measuring rod method for the coaxiality of serial holes

A Novel Method For The Micro-Clearance Measurement Of A Precision Spherical Joint Based On A Spherical Differential Capacitive Sensor

Device for in-situ measurement of anisotropic parameters of soil body in hole

Ultraprecision Diameter Measurement of Small Holes with Large Depth-To-Diameter Ratios Based on Spherical Scattering Electrical-Field Probing

Fast and Accurate Measurement of Hole Systems in Curved Surfaces

A New Method to Measure the Taper of Part Hole by Pneumatic-to-current