NiAlFe catalysts based on hydrotalcite-like precursors for low temperature CO 2 methanation: Electronic effects among components and intrinsic activity of Ni site
Xu Hu,Xiaoming Guo,Tao Meng,Qiangsheng Guo,Jinglin Cheng,Yanzhe Wang,Wenzhu Huang,Flora T.T. Ng
DOI: https://doi.org/10.1016/j.apsusc.2024.160705
IF: 6.7
2024-07-15
Applied Surface Science
Abstract:NiAlFe catalysts based on the hydrotalcite-like precursor were prepared and the catalysts exhibit excellent low temperature catalytic activity for CO 2 methanation. CO 2 conversion over the NiAlFe 0.3 catalyst is nearly 80 % under the condition of T = 225 °C, P = 1 atm, and WHSV = 24000 mL/(g∙h). With the increase in the substitution of Fe for Al, the hydrotalcite-like structure of the catalyst precursor is gradually destroyed; the reducibility of NiO component is promoted; the amount of surface basic site decreases. There is a strong electronic push–pull effect between NiO and Al 2 O 3 in the calcined catalyst, and the electronic effect is weakened with the introduction of Fe because Fe 3+ shares the responsibility of Ni 2+ for donating electron to Al 3+ . In the reduced catalysts, the Ni 3 Fe alloy was formed and the electrons are pushed from Ni 0 to Fe 0 . With the increase in the Fe amount, the number of surface Ni atom decreases, while the intrinsic activity of Ni active site enhances. The number and intrinsic activity of Ni site are the main two factors determining the CO 2 methanation activity at low temperature. Moreover, the substitution of Al 3+ by Fe 3+ is beneficial for the stability of the catalysts by inhibiting the agglomeration of catalyst particle.
materials science, coatings & films,physics, applied,chemistry, physical, condensed matter