Abstract:High-energy-density batteries are actively sought after for next-generation electric vehicle (EV) applications, triggering the search for sulfur-based positive electrode materials with high capacity for extended driving range. One of the primary issues of sulfur cathodes is the rapid capacity decay caused by the dissolution of sulfur in the electrolyte and the resulting parasitic reactions. This can be prevented by incorporating a suitable amount of carbon material into the sulfur electrodes, because of its inherent properties; however, introducing a large amount of low-density carbon materials will lead to a decrease in the energy density of the battery. Therefore, an alternative method to suppress sulfur dissolution is required for commercial applications. Recently, we developed a Fe-containing Li2S-based material (Li8FeS5) as the sulfur cathode; it has a relatively high initial discharge capacity (>700 mAh·g−1) and electric conductivity. However, rapid capacity degradation was observed during the initial several cycles, due to some unknown reactions between the electrolyte and Li8FeS5. In this study we demonstrate an effective method to improve the cycle performance of Li8FeS5 by coating its surface with a stabilizing material. We selected titanium oxide as the coating material, based on its high stability toward liquid electrolytes and its strong interaction with sulfur. Hence, we obtained TiOx-coated Li8FeS5 particles (Li8FeS5-TiOx) by a liquid-phase reaction. The transmission electron microscopy observation revealed that the Li8FeS5 particles were coated with several tens of nanometers of TiOx layers. The Li8FeS5-TiOx cells exhibited improved cycling performance with a carbonate electrolyte. We also observed that the capacity originating from an iron redox was not affected by coating during the cycling test; in contrast, the degradation of the cell capacity corresponding to the sulfur redox was suppressed significantly after coating with the TiOx layer. Thus, the surface reaction of Li8FeS5 with the electrolyte, which could be the main reason for the cycling degradation, was effectively suppressed by coating with the TiOx layer.

Coating with SiO2 alleviates the capacity decay of FeTiO3 for lithium storage

Introduction of amorphous TiO2 coating layer to improve the lithium storage of SiO2 nanospheres anode

TiO2 Coated Si/C Interconnected Microsphere with Stable Framework and Interface for High-Rate Lithium Storage

Carbon-coated Fe3O4 nanocomposites anchored on Ti3C2 nanosheets for enhanced Li-storage

Novel Construction of Heterostructured FeTiO 3 /Fe 2.75 Ti 0.25 O 4 Mesoporous Nanodisks with Both High Capacity and Stable Cycling Life for Lithium-Ion Storage

Electrochemical Properties of MIL‐100(Fe) Derived Double‐Shell Coating Anode Materials for Lithium‐Ion Battery

Boosting Conversion of the Si-O Bond by Introducing Fe2+ in Carbon-Coated SiOx for Superior Lithium Storage

Core–Double-Shell TiO2@Fe3O4@C Microspheres with Enhanced Cycling Performance as Anode Materials for Lithium-Ion Batteries

Improvement of Cycling Capability of Li2S-FeS Composite Positive Electrode Materials by Surface Coating With Titanium Oxide

Novel Construction of Heterostructured FeTiO<sub>3</sub>/Fe<sub>2.75</sub>Ti<sub>0.25</sub>O<sub>4</sub> Mesoporous Nanodisks with Both High Capacity and Stable Cycling Life for Lithium-Ion Storage

Study of TiO2-Coated Α-Fe2o3 Composites and the Oxygen-Defects Effect on the Application As the Anode Materials of High-Performance Li-Ion Batteries

Core-Shell Si@Tio2 Nanosphere Anode by Atomic Layer Deposition for Li-Ion Batteries

SiO@C/TiO2 nanospheres with dual stabilized architecture as anode material for high-performance Li-ion battery

Effect of TiO2-coating on the Electrochemical Performances of LiCo1/3Ni1/3Mn1/3O2

Double Core-Shell Si@C@SiO2 for Anode Material of Lithium-Ion Batteries with Excellent Cycling Stability.

Enhancing the Electrode Performance of Co3O4 Through Co3O4@a-TiO2 Core–shell Microcubes with Controllable Pore Size

Chemically-confined mesoporous γ-Fe2O3 nanospheres with Ti3C2Tx MXene via alkali treatment for enhanced lithium storage

Preparation of carbon‐coated Fe2O3@Ti3C2Tx composites by mussel‐like modifications as high‐performance anodes for lithium‐ion batteries

Ultrafine Fe2VO4 nanoparticles anchored on Ti3C2Tx nanosheets (Fe2VO4@Ti3C2Tx) as high-energy anode for lithium-ion storage

Improving the lithium storage performance of micro-sized SiO particles by uniform carbon interphase encapsulation and suitable SiO2 buffer component

Highly Graphitized Carbon Coating on SiO with a π–π Stacking Precursor Polymer for High Performance Lithium-Ion Batteries