Abstract:PurposeThe micro-vibrations of some flexible appendages onboard satellite such as reaction wheels, scanning mechanisms etc, will severely influenced the optical precision of the imager. To guarantee the imager orientation accuracy of high resolution satellite, this study focused on designing an isolation system to attenuate the influences of on orbit micro-vibration.MethodsStwart configuration is employed to construct the reaction wheel isolation system which contains six single isolators. A launch environment damper is designed to guarantee the structure safety of isolators without lock mechanisms at launching term which simplify the whole isolation system. The imager isolation system is composed of three special springs which are placed between imager basement and roof board of the satellite to isolate the disturbances to the imager. Both isolation systems are compose together for the satellite to attenuate the influences of on orbit micro-vibration.ResultsExperiments are designed to validate the productivity of the micro-vibration isolation system both in component and satellite level. The sine vibration experiment results show that the maximal acceleration output 34.61g is much lower than the flywheel design value 49g which guarantees the safety of flywheel under harsh launch environment. The experiment results in satellite level show that the vibration output in three directions changes smoothly and the imager orientation accuracy is 10.89urad (3σdocumentclass[12pt]{minimal}usepackage{amsmath}usepackage{wasysym}usepackage{amsfonts}usepackage{amssymb}usepackage{amsbsy}usepackage{mathrsfs}usepackage{upgreek}setlength{oddsidemargin}{-69pt}egin{document}$$3sigma$$end{document}) which is suitable for the requirement of the imager onboard the SDLT-1 satellite.ConclusionThe proposed method has been applied to the SDLT-1 satellite and the experiment results in component and satellite level show the feasibility of the method. Some satellite with rigorous micro-vibration requirement could employ the proposed method of this study.

Micro-vibration suppression and compensation techniques for in-orbit satellite: A review

Vibration Detection and Calibration Method Used to Remote Sensing Optical Camera

Electromechanical co-simulation analysis for contactless positioning and vibration isolation platform

Advances in spacecraft micro-vibration suppression methods

Effect of satellite micro-vibration on imaging quality for optic payload

Image tremble compensation for space camera

Time-delay compensation for stabilization imaging system

Study On Mtf Of Remote Sensing Imaging Under Arbitrary Known Vibration

Micro-Vibration Analysis, Suppression, and Isolation of Spacecraft Flywheel Rotor Systems: A Review

Micro-vibration simulation of laser communication satellite subjected to the disturbance of momentum wheels

Study on Micro-vibration Isolation System Design and Validation for the SDLT-1 Satellite of China

Modeling and analysis of a viscoelastic micro-vibration isolation and mitigation platform for spacecraft

Micro-vibration control of spaceborne payload with smart parallel struts

Experimental modeling and optimization of single-gimbal CMG vibration isolator

Vibration isolation methods in spacecraft: A review of current techniques

Design and Experimental Study of a Hybrid Micro-Vibration Isolation System Based on a Strain Sensor for High-Precision Space Payloads

Benefit of Relaxation-Type Damping on the Performance of a Six-Degree-of-Freedom Microvibration Isolation Device for Control Moment Gyroscope

Prescribed modal vibration control and disturbance load analysis of rigid-flexible satellites

Design of a Maglev Stewart Platform for the Microgravity Vibration Isolation

Study of Whole-Satellite Active Vibration Isolation Platform

Micropositioning and microvibration isolation of a novel hybrid active–passive platform with two-axis actuator for optical payloads