Abstract:The modulation transfer function (MTF) serves as a crucial technical index for assessing the imaging quality of remote sensing cameras, which is integral throughout their entire operational cycle. Currently, the MTF evaluation of remote sensing cameras primarily relies on the slanted-edge method. The factors influencing the slanted-edge method’s effectiveness are broadly classified into two categories: algorithmic factors and image factors. This paper innovatively comprehensively analyzes the influencing factors of the slanted-edge method and proposes an improved slanted-edge method to calculate the MTF testing method of remote sensing cameras, which is applied to the MTF testing of remote sensing cameras. Since the traditional algorithm can only be applied in the small angle situation, this paper proposes a new method of slanted-edge method test calculation based on the optimal oversampling rate (OSR) adaptive model of the slanted edge and uses simulation experiments to verify the reliability of the algorithm model through the deviation of the slanted-edge angle calculation and MTF measurement, and the results show that the algorithm improves the accuracy of the MTF measurement compared with the ISO-cos and OMINI-sine methods. Then, the effects of the slanted-edge angle, image region of interest (ROI), as well as image contrast and signal-to-noise ratio (SNR) on the accuracy of the MTF calculation by the slanted-edge method were quantitatively analyzed as the constraints of the slanted-edge method test. Based on the laboratory target experiment, the algorithm flow and various influencing factors obtained in the simulation stage are verified, and the experimental results are more consistent with the various test results obtained in the simulation stage. Consequently, the slanted-edge method introduced in this paper is applicable for future remote sensing camera MTF testing. This approach offers a valuable reference for on-orbit focusing, satellite operational condition monitoring, lifespan estimation, and image restoration.

Study On Mtf Of Remote Sensing Imaging Under Arbitrary Known Vibration

Analysis of the Simulation Model Based on Remote Sensing Imaging under Vibration

Vibration Detection and Calibration Method Used to Remote Sensing Optical Camera

Image tremble compensation for space camera

Degradation of modulation transfer function in push-broom camera caused by mechanical vibration

Image Quality Degradation Analysis Induced by Satellite Platform Harmonic Vibration

Efficient Assessment Method of On-Board Modulation Transfer Function of Optical Remote Sensing Sensors

Degradation of Image Quality Caused by Vibration in Push-Broom Camera

Simulation Analysis Of Platform Vibration On Image Quality Of Satellite-Based High-Resolution Optical System

Simulation Of Imaging Spectrometers Degraded By Satellite Vibrations

Analysis and Simulation of Images Degraded by Complex Vibration

Effect of satellite micro-vibration on imaging quality for optic payload

Evaluation of Influences of Frequency and Amplitude on Image Degradation Caused by Satellite Vibrations

Modeling And Simulation Of The Degradation Caused By The Satellite Vibration

Error Tolerance and Effects Analysis of Satellite Vibration Characteristics and Measurement Error on TDICCD Image Restoration

Distributed Measurement of Micro-vibration and Analysis of the Influence on Imaging Quality.

Numerical calculation and analysis of dynamic MTF

Analysis of the Slanted-Edge Measurement Method for the Modulation Transfer Function of Remote Sensing Cameras

MTF Measurement Research on Satellite Remote Sensing Images Based on the Knife-Edge Method

Experimental study on MTF of remote sensing image

Statistic Estimation and Validation of In-Orbit Modulation Transfer Function Based on Fractal Characteristics of Remote Sensing Images