Abstract:Syngas fermentation is one of the bets for the future sustainable bio‐based economy due to its potential as intermediate step in the conversion of waste carbon to ethanol fuel and other chemicals. Integrated with gasification and suitable downstream processing, it may constitute an efficient and competitive route for the valorization of various waste materials, especially if systems engineering principles are employed targeting process optimization. In this study, a dynamic multi‐response model is presented for syngas fermentation with acetogenic bacteria in a continuous stirred tank reactor, accounting for gas‐liquid mass transfer, substrate (CO, H2) uptake, biomass growth and death, acetic acid re‐assimilation and product selectivity. The unknown parameters were estimated from literature data using the Maximum Likelihood Principle with a multi‐response nonlinear modeling framework and meta‐heuristic optimization; and model adequacy was verified with statistical analysis via generation of confidence intervals as well as parameter significance tests. The model was then used to study the effects of process conditions (gas composition, dilution rate, gas flow rates and cell recycle) as well as the sensitivity of kinetic parameters, and multi‐objective genetic algorithm was used to maximize ethanol productivity and CO conversion. It was observed that these two objectives were clearly conflicting when CO‐rich gas was used, but increasing the content of H2 favored higher productivities while maintaining 100% CO conversion. The maximum productivity predicted with full conversion was 2 g.L‐1.h‐1 with a feed gas composition of 54% CO and 46% H2 and a dilution rate of 0.06 h‐1 with roughly 90% of cell recycle.This article is protected by copyright. All rights reserved.

Method to obtain parameters k2, k3 for dilution rate observer in AM2 model of the anaerobic digestion process in a batch reactor

Examining a Pretty Simple and Low Cost Method for Modeling of Biogas Production from Biodegradable Solids

Identification in an anaerobic batch system: global sensitivity analysis, multi-start strategy and optimization criterion selection

Mathematical Model of Anaerobic Propionate Degradation by Incorporating the R/k Selection Theory

Application of Anaerobic Digestion Model No. 1 to describe the syntrophic acetate oxidation of poultry litter in thermophilic anaerobic digestion

Kinetic characteristics of biological simultaneous anaerobic sulfide and nitrite removal

Modification of Anaerobic Digestion Model No. 1 for modeling anaerobic digestion of cattle manure with changing solids retention time

Monitoring management criterion of an anaerobic digester using an explicit model based on temperature and pH

Investigating the Possibility of Applying an ADM1 Based Model to a Full-Scale Co-Digestion Plant

Kinetic Characteristics and Microbial Community of Anammox-EGSB Reactor

Soft sensor for substrate characterization through the reverse application of the ADM1 model for anaerobic digestion plant operations

A NOVEL MATHEMATICAL MODEL FOR PREDICTING PERFORMANCE OF THE SEQUENTIAL BATCH ANAEROBIC DIGESTION PROCESS: PART I

Dynamic model adaptation to an anaerobic digestion reactor of a water resource recovery facility

Kinetic Study of Anaerobic Digestion of Compost Leachate from Organic Fraction of Municipal Solid Waste

The operating diagram for a two-step anaerobic digestion model

Modeling of anaerobic formate kinetics in mixed biofilm culture using dynamic membrane mass spectrometric measurement

Modeling key intermediates during anaerobic digestion of lipid rich kitchen waste with an extended ADM1

Modeling and Parameters Identification of 2-Keto-l-gulonic Acid Fed-Batch Fermentation.

Nonlinear Model Predictive Control Of Anaerobic Digestion Process Based On Reduced Adm1

Dynamic modeling of syngas fermentation in a continuous stirred‐tank reactor: Multi‐response parameter estimation and process optimization

Global Analysis of a Simplified Model of Anaerobic Digestion and a New Result for the Chemostat