Abstract:The surface temperature retrieval of high-temperature objects shielded by strong diffusive mist plays a critical role in aerospace, metallurgical and many other industries. Traditional radiation temperature measurements under extreme conditions usually cause substantial errors because of the strong extinction and scattering by mist during light propagation. The current infrared temperature retrieval methods often use single-channel or double-channel non-imaging temperature measurement strategies. In such methods, the temperature is corrected using either pre-measured or real-time mist parameters, and the results are analyzed and evaluated according to radiative transfer theory. Based on the calculated spectral radiation characteristics of mist, this paper proposed an infrared imaging temperature measurement method. A temperature retrieval model is also built based on radiative transfer theory while the adjacent effect is considered. The exact surface temperature distribution can be retrieved while the parameters of the diffusive mist medium remain unknown. During a typical temperature retrieval process, the radiative temperature distribution is firstly calculated according to the infrared images in three different channels calibrated by the pre-acquired calibration and emissivity data. Then the exact temperature is retrieved according to this non-linear temperature retrieval model. A three-channel infrared temperature retrieval system is designed, with its three channels centered at 8.8, 10.7, and 12.0 mu m, respectively. Three identical long-wave infrared focal plane detector is applied, which can simultaneously photograph the high-temperature object. Besides, an experimental verification device is assembled to test the performance of the three-channel infrared system based on a high-temperature blackbody and a home-made mist generator. The results prove that long-wave infrared shows a higher interference resistance capacity than mid-wave infrared. This three-channel device and the temperature retrieval model reduce the image distortion caused by mist and show an average temperature retrieval error of ca. 7% at 1 000, 1 100, and 1 200 degrees C conditions. This method is suitable for both high-temperature blackbody and graybody, while the pre-acquisition of the mist parameters is not required. The temperature retrieval method based on multi-spectral infrared imaging proposed in this article shows universal applicability and considerable innovativeness.

Image temperature calculation for gas and particle system by the mid-infrared spectrum using DRESOR and SNBCK model

Examining Asian Dust Refractive Indices for Brightness Temperature Simulations in the 650–1135 Cm−1 Spectral Range

Analysis of Multi-Factor on Measurement Improvement of an Infrared Imager in Low-Temperature Environments

An Efficient Temperature Calibration Method Based on the Improved Infrared Forward Model and Bayesian Inference

Impacts of scattering of non-gray gas particulate mixtures on radiative heat transfer and mid-infrared image temperature in a 2D oxy-coal combustion furnace

Assessment of the Accuracy of the Conventional Ray-Tracing Technique: Implications in Remote Sensing and Radiative Transfer Involving Ice Clouds

An Accurate and Efficient Radiative Transfer Model for Simulating All-Sky Images from Fengyun Satellite Radiometers

Retrieval of High-Temperature Field under Strong Diffusive Mist Medium Via Multi-Spectral Infrared Imaging

Real-Time Simulation of Clear Sky Background Radiation in Gas Infrared Remote Sensing Monitoring

Algorithm of Emissivity Spectrum and Temperature Separation Based on TASI Data

Photometric Correction for Infrared Sensors

Temperature and Emissivity Retrieval from Hyperspectral Thermal Infrared Data Using Dictionary-Based Sparse Representation for Emissivity

Measuring Thermal Emission Near Room Temperature Using Fourier-Transform Infrared Spectroscopy

Spatial Scale Issue In Temperature And Emissivity Separation From Thermal Hyperspectral Imager

An optimized emissivity and temperature separation from hyperspectral thermal infrared data

Dual-Interference Channels Static Fourier Transform Imaging Spectrometer Based on Stepped Micro-Mirror: Data Processing and Experiment Research

Correcting Thermal-Emission-induced Detector Saturation in Infrared Spectroscopy

A Numerical Simulation Method for Aircraft Infrared Imaging

Temperature And Emissivity Separation From Tasi Data Based On Wavebands Selection

Evaluation of Radiometric Performance for the Thermal Infrared Sensor Onboard Landsat 8

Multi-Spectral Radiation Temperature Measurement: A High-Precision Method Based on Inversion Using an Enhanced Particle Swarm Optimization Algorithm with Multiple Strategies