Abstract:The application of 3D printing technology for replicating natural rock models and achieving the visualization and quantification of hidden structural changes and stress evolution in underground rocks holds significant importance for engineering disaster prevention as well as the development of oil and gas resources. The key to achieving this lies in developing model materials suitable for 3D printing that accurately depict the physical and mechanical properties of rocks. In this paper, the impact of temperature cycle treatment on the mechanical properties of printing material VeroClear was tested and the effect of temperature on the stress-optical properties of VeroClear was analyzed. By using 3D printing models with pre-existing cracks, the crack initiation conditions, propagation laws and stress field distribution characteristics of stress-sensitive materials at different temperatures were obtained. The results show that the mechanical properties of the freshly printed VeroClear model exhibit instability due to incomplete curing. Heat treatment can facilitate complete curing and enhance their mechanical characteristics, whereas cold treatment fails to yield similar improvements. Lower ambient temperatures reduce photoelastic fringe susceptibility to stress, yet allow accurate quantification of full-field stress within models by VeroClear. Lowering the temperature significantly enhances the brittleness of VeroClear, enabling printed models to demonstrate crack evolution characteristics similar to those observed in actual rocks. By analyzing the evolution of photoelastic fringe, it is found that the wing crack propagates along the direction of the local minimum principal stress difference near the crack tip. These findings provide a foundation for utilizing stress-sensitive materials with enhanced brittleness in low-temperature environments for simulating rocks and quantitatively analyzing their fracture behavior and the role of stress field control.

Photoelastic stress response of complex 3D-printed particle shapes

3D Printable Elastomers with Exceptional Strength and Toughness

Determination of the Stress and Strain Fields in Porous Structures by Photoelasticity and Digital Image Correlation Techniques

3D Printable Ultra-Strong Elastomers Rivaling Spider Silk

Determination of the Full-Field Stress and Displacement Using Photoelasticity and Sampling Moiré Method in a 3D-Printed Model

Visualization method for stress-field evolution during rapid crack propagation using 3D printing and photoelastic testing techniques

By Visualizing the Deformation with Mechanoluminescent Particles, Additive Manufacturing Offers a Practical Alternative to Stress and Strain Simulation

Visualization of the three-dimensional structure and stress field of aggregated concrete materials through 3D printing and frozen-stress techniques

Quantification of full-field stress in continuously loaded fractured rocks using 3D printing and digital photoelasticity

Integrated photoelasticity in a soft material: phase retardation, azimuthal angle and stress-optic coefficient

Characterization of stress field evolution during 3D internal fracture propagation using additively printed models and frozen stress techniques

Particle Shape Effects on the Stress Response of Granular Packings

Operando neutron diffraction reveals mechanisms for controlled strain evolution in 3D printing

Elasto-plastic residual stress analysis of selective laser sintered porous materials based on 3D-multilayer thermo-structural phase-field simulations

Mechanical nanolattices printed using nanocluster-based photoresists

Study on mechanical properties of 3D printed rock mass samples with photosensitive resin material

Photoelastic Study Of Force Chains

New insights into the effects of low temperatures on the stress-optical properties of printable photopolymers: An experimental investigation

Mechano-luminescence Behavior of Lanthanide-Doped Fluoride Nanocrystals for Three-Dimensional Stress Imaging

Tomographic eigenstrain reconstruction for full-field residual stress analysis in large scale additive manufacturing parts