The PEMFC-MHP-CHP system for independent energy supply and peak shaving: Performance analysis under load fluctuations

Sen Yu,Yi Fan,Zhengrong Shi,Jingkui Zhang,Xudong Zhao,Jiakai Zhang,Yuqi Zhang
DOI: https://doi.org/10.1016/j.ijhydene.2023.12.163
IF: 7.2
2024-01-01
International Journal of Hydrogen Energy
Abstract:The Proton Exchange Membrane Fuel Cell - Mechanical Heat Pump - Combined Heat and Power (PEMFC-MHP-CHP) system is a reliable energy supply solution, which can operate independently of the grid during emergencies or be used for peak shaving and load leveling in renewable energy networks. This paper proposes two system structures, namely the separated and integrated systems and establishes MATLAB/Simulink models. Then, a sensitivity analysis is conducted, examining system design and operation. The results show that the separated system can satisfy basic heating and electricity demands without an external power supply at −14.5 °C. Increasing the number of cells by 20, reducing one room's heat load (36 m2), or increasing the current density by 0.1 A/cm2 results in reductions in compressor power consumption ranging from 1.76 % to 2.91 %, 7.42 %–10.57 %, and 6.52 %–16.88 %, respectively. On the other hand, the integrated system has higher power consumption but can operate smoothly at lower temperatures than the separated system. It is suitable for integration with auxiliary power devices in low-temperature environments. The PEMFC's heat output minimally affects system efficiency. Reducing the number of rooms improves system performance, with each reduction of one room decreasing compressor power consumption by 5.43 %–8.55 %. Meanwhile, two design options are identified based on the power supply and hot water demands. Further research and development can enhance the efficiency and performance of these systems, promoting their wider use in the future.
energy & fuels,electrochemistry,chemistry, physical
What problem does this paper attempt to address?