Abstract:The excellent mechanical and physical properties of Ti6Al4V titanium alloy make it a good candidate material for a broad range of applications, with special relevance for the aerospace industry. As a difficult-to-cut alloy, it represents a great challenge to improve its machinability and surface integrity while simultaneously avoiding the high time consuming and cost of the experiments. Modelling and simulation of the machining process offer a cost-effective method to investigate the machining process. In this work, an orthogonal cutting model of Ti-6Al-4 V alloy was developed and used to simulate the major cutting outcomes, including: forces, temperature distribution, chip geometry, chip compression ratio and residual stresses in the machined surface and subsurface. This cutting model includes a constitutive model accounting for the state of stress and the strain-rate effects on the mechanical behaviour (plasticity and damage) of Ti-6Al-4 V alloy in metal cutting. In addition, Zorev contact model is used to simulate the contact stresses at both tool-chip and tool-workpiece interfaces. The proposed cutting model could predict relatively well the major cutting outcomes for seven cutting conditions. The difference between simulated and experimental cutting forces is less than 14%, but the predicted thrust force is underestimated about 53% in maximum. The difference between simulated and measured maximum compressive residual stresses in cutting and transversal directions can reach in average about 17% and 36%, respectively. The maximum difference between predicted and measured thicknesses of the layer affected by residual stresses is less than 19%. This study highlights several critical points affecting the thrust force and the residual stress predictions, which should be considered in future developments of cutting models.

Measurement of Residual Stress in Titanium Alloy Wide-Chord Hollow Fan Blade Based on Multiple-Cut Contour Method

Numerical simulation on surface residual stress for titanium alloy

Three-dimensional modeling and reconstructive change of residual stress during machining process of milling, polishing, heat treatment, vibratory finishing, and shot peening of fan blade

Mechanical response analysis of the wide-chord hollow fan blade considering the fluid–structure interaction

Measuring Residual Stresses in Linear Friction Welded Joints Composed by Dissimilar Titanium

Characterization of Local Residual Stress at Blade Surfaces by the V(z) Curve Technique

Numerical investigations on residual stresses in orthogonal cutting of Ti-6A1-4V

Research on the Explosion Release Method and Damage Mechanism of Titanium Alloy Fan Blade

Analysis and design optimization of double-sided deep cold rolling process of a Ti-6Al-4V blade

Fem Analysis and Experimental Study on Residual Stress Induced by Form-Milling and Rolling of Rotor Steel 26Nicrmov145

Simulation Study on Residual Stress Distribution of Machined Surface Layer in Two-Step Cutting of Titanium Alloy

Experimental Investigation of Effects of Polishing Process on Surface Residual Stress of TC4 Blade Based on Sensitivity Analysis

Modelling orthogonal cutting of Ti-6Al-4 V titanium alloy using a constitutive model considering the state of stress

Non-contact Measurements of Residual Stress Distribution and Grain Size in Titanium Alloys with Laser Ultrasonic System

Theoretical investigation of machining-induced residual stresses in longitudinal torsional ultrasonic–assisted milling

Characterization Of Local Residual Stress On Curved Blades By Ultrasound

Machining mechanism and stress model in cutting Ti6Al4V

Experimental study on surface residual stress of titanium alloy curved thin-walled parts by ultrasonic longitudinal-torsional composite milling

Predicting Surface Residual Stress for Multi-Axis Milling of Ti-6Al-4V Titanium Alloy in Combined Simulation and Experiments

Effects of Different Materials on Residual Stress Fields of Blade Damaged by Foreign Objects

Effects of Laser Shock Processing with Different Parameters and Ways on Residual Stresses Fields of a TC4 Alloy Blade