Abstract:A study on austenitic stainless steel (STS304 TKC and STS316 TKC) square hollow section(SHS) columns subjected to centrally axial compression has been conducted to investigate the buckling behaviors of the compression members with both fixed ends. Main variables are steel type, column length and width-thickness ratio. Buckling modes at ultimate state were classified into two such as local buckling and global buckling. Compressive material properties of SHS members was also investigated through stub column tests in addition to tensile material properties. Stub columns showed local buckling mode. A finite element (FE) analysis model of a stainless steel SHS column considering initial geometric imperfection and compressive material properties was developed, and the validity of the FE analysis procedure was verified through comparison with test results. The test buckling strengths were compared with the strengths predicted by current stainless steel design specifications (American Society of Civil Engineers (ASCE 8–22) and Eurocode (EC3)). As a result, it is found that design strengths with compressive material test data of stub column than those of tensile coupon were close to test buckling strength. The global buckling coefficients of ASCE 8–22 was the values presented for the compression members of open sections, and since it did not sufficiently reflect the buckling characteristics of the closed-section SHS members, some of the buckling coefficients were adjusted upward referring to the AISC 370–21 specification. The EC3 standard presented a value with the adjusted initial imperfection coefficient. It was confirmed that the predicted strength by the design equations with the modified coefficient was close to the test and analysis buckling strength.

Buckling Strength of Cold-Formed Austenitic Stainless Steel SHS Columns Subjected to Concentric Axial Load

Global Buckling of S35657 Austenitic Stainless Steel Welded Box- and I-section Long Columns under Axial Compression

Design of Austenitic and Duplex Stainless Steel SHS and RHS Beam-Columns

Structural behaviour of high strength steel hexagonal hollow section stub columns under axial compression

Testing and design of cold-formed high strength steel square hollow section columns

Compression tests on local buckling behavior of welded stainless steel Ⅰ-section stub columns

Compressive Behaviour of Corroded Thin-Walled Circular Section Steel Stub Columns

Local Buckling of 460mpa High Strength Steel Welded Section Stub Columns under Axial Compression

Analysis of Flexural Buckling Capacity of Stainless Steel Columns under Axial Compression

Flexural buckling of cold-formed austenitic stainless steel flat-oval hollow section columns: Testing, modelling and design

Design of Cold-Formed Stainless Steel RHS and SHS Beam–columns at Elevated Temperatures

Local Buckling Behavior of Welded Stub Columns with Normal and High Strength Steels

Experimental study on bearing capacity of austenitic stainless steel lipped channel columns

Stub Column Tests of Thin-Walled Complex Section with Intermediate Stiffeners

Numerical investigation and design for the local buckling behaviour of high strength steel hexagonal hollow section stub columns under axial compression

Behavior of High Strength Steel Columns under Axial Compression

Local buckling analysis of axially compressed welded box-section stub columns using Q420–Q960 steel

Local Buckling Behaviour of Stainless-Clad Bimetallic Steel Built-Up Square Hollow Section Stub Columns

Cross-section behaviour of cold-formed high strength steel irregular hexagonal hollow section stub columns under combined compression and bending

Experimental Study on Column Buckling of 420 MPa High Strength Steel Welded Circular Tubes

Stub Column Tests on Stainless Steel Built-Up Sections