Abstract:This research paper presents a new flexural design approach for cold-formed steel (CFS) built-up sections failing in local buckling, developed following an extensive numerical investigation involving two novel closed built-up sections. At first, a finite element (FE) model using the widely adopted ABAQUS software was constructed and carefully validated against pertinent experimental data available in the literature. A comprehensive validation process which included comparing flexural strengths, deformed shapes, moment-curvature, and moment-displacement curves was performed. Afterwards, the validated FE model was extended to a numerical parametric investigation comprising of 108 simulations involving both three-point and four-point bending cases. Key parameters, including cross-sectional shapes, slenderness, and screw spacing, were varied primarily to facilitate the formulation of the novel design method. The outcomes of this investigation revealed that the current direct strength method (DSM) available in the North American Specifications (NAS) underestimated the bending strength, particularly for the ultra-thin sections. Considering this observation which is consistent with the findings of past research on similar cross-sections, a Generalised Direct Strength Method (DSM-G) was developed by introducing a new mathematical model, which differs from the traditional slenderness limit equations, instead relying on a conservativeness degree-based approach used for modifying the original DSM equations. The DSM-G method demonstrated a better accuracy in predicting the flexural strengths of different built-up sections (including the ones investigated by other researchers), all failing by local buckling. Moreover, the reliability of DSM-G equations was assessed, satisfying the prescribed threshold index limit suggested in NAS. A comprehensive set of guidelines, along with a design example for implementing the DSM-G method, has been presented to facilitate practical application.

Flexural resistance of thin-web singly-symmetric steel I-sections exhibiting early tension flange yielding

Critical Load for Shear-Induced Lateral-Distortional Buckling in I-section Steel Beams Considering Flexural Stiffness Ratio

Experimental Investigation into Flexural Buckling of Double-Limb Built-Up Plate Members under Compression

Flexural Behavior of Circular Section Concrete-Filled Steel Tubes with Embedded Latticed Angles

Elastic Buckling of Web Restrained by Flanges in I-section Members

Behavior and Design of Slender Concrete-Filled Wide Rectangular Steel Tubular Columns under Axial Compression

Flexural Tests and Behavior of Multi-Celled Corrugated-Plate CFST Members

Experimental Investigation and Design of Thin- Walled Concrete-Filled Steel Tubes Subject to Bending

Tension-Flange Restraint Effect on Lateral-Torsional Buckling Moment Capacity of Web-Tapered Steel I-Sections

FLEXURAL BEHAVIOUR OF THIN-WALLED DODECAGONAL SECTION DOUBLE SKIN CONCRETE-FILLED STEEL TUBES

Flexural behavior and design of rectangular ultra-high performance concrete-filled high-strength steel tube members

Compressive Behavior and Design Calculations of CFST Slender Columns with Latticed Annular Steel Part

Experimental Investigation And Design Of Concrete-Filled Cold-Formed Thin-Walled Steel Tubes Subject To Bending

Flexural design of cold-formed steel built-up sections failing by local buckling: Development of generalised direct strength method

Flexural Performance of Rectangular Cfst Members

Lateral-torsional buckling behaviour of concrete-filled high-strength steel tubular flange beams under mid-span load

Flexural Behaviour of Round-Ended CFST Members: Testing, Numerical Analysis, and Design

Experimental and numerical investigation on flexural-torsional buckling of Q460 steel beams

Numerical Investigation and Design Rules for Flexural Capacities of H-section High-Strength Steel Beams with and Without Web Openings

Local buckling behavior of high strength steel welded I-section flexural members under uniform moment:

Design for local buckling behaviour of welded high strength steel I-sections under bending