Abstract:The cavitation damage in the Engine cooling water pump (ECWP) is the key factor that shortens the lifespan of automobile cooling systems, and causes vibration and noise. To improve cavitation performance and external characteristics of ECWP, three optimized models were designed on the basis of WP7 diesel ECWP. The whole flow fields in three models and the prototype pump were numerically simulated, employing the time averaged Navier-Stokes equation, the standard k-ε turbulent model and Zwart-Gerber-Belamri multiphase flow model by ANSYS-CFX software. Pressure distribution, turbulent kinetic energy distribution, bubble volume fraction distribution, external characteristics and cavitation performance of the prototype pump and optimized models were compared and analyzed. The results show that the external characteristics and cavitation performance of the optimized models are significantly better than that in the prototype pump. Through decreasing the inlet blade angle and wrap angle, extending the blade to inlets and extending a certain inclination in the blade, shock loss in blade inlet was reduced and so, the performance of pump will be improved. The flow condition at blade inlet will also be improved greatly, which in turn improves cavitation performance. When reducing the quantity of blades, the excretion coefficient will drop, flow area of blade inlet becomes bigger, but head has a little drop. And the pump optimized by reducing the quantity of blades has the optimal cavitation performance among three optimized models. With the decrease of impeller diameter, the absolute pressure in the critical cavitation point becomes bigger, the inlet bubble volume fraction at the same absolute pressure increases while cavitation performance gets worse. The obtained numerical results were compared with the experimental ones, and the outcome showed the same tendency between the two along with acceptable error.

From sucking worms to Windkessel: The physics of an early eighteenth century firefighting device

A hydrostatic model of the Wirtz pump

Investigation into the Effects of the Variable Displacement Mechanism on Swash Plate Oscillation in High-Speed Piston Pumps

Experimental and Numerical Studies on Erosion Damage in Damping Holes on the Valve Plate of an Axial Piston Pump

Dynamic Interaction Between Valve-Closure Water Hammer Wave and Centrifugal Pump

Cavitation Performance Improvement of High Specific Speed Mixed-Flow Pump

Definitionssache: Turbulenzen, Selbstbelüftung und Wasser-Luft-Abfluss auf Schussrinnen

A more thorough analysis of water rockets: Moist adiabats, transient flows, and inertial forces in a soda bottle

A Model for Predicting the Trajectory and Structure of Firefighting Hose Streams

Development of A Physical Windkessel Module to Re-Create In-Vivo Vascular Flow Impedance for In-Vitro Experiments

Stability Analysis of Vaneless Space in High-Head Pump-Turbine under Turbine Mode: Computational Fluid Dynamics Simulation and Particle Imaging Velocimetry Measurement

Numerical Study on the Stall Behavior of a Water Jet Mixed-Flow Pump

Evaluating Jacob Bernoulli's Ship Propulsion Artifice: Euler's Analysis and Critique

The Rise of Water at A Ship Stem

Modeling Green Water Load on a Deck Mounted Circular Cylinder

THE WIND TUNNEL DEVELOPMENT OF A PROPOSED EXTERNAL FORM FOR STEAM LOCOMOTIVES

A pressure compensation method and its application in cavitation suppression of swash plate axial piston pump

Pulsed combustion of fuel–air mixture in a cavity above water surface: modeling and experiments

An elementary model for an advancing autoignition front in laminar reactive co-flow jets injected into supercritical water

Numerical calculation and optimization designs in engine cooling water pump

Rotordynamics of a Two-Phase Flow Twin Screw Pump