A simple and effective host for sodium metal anode: 3D printed high pyrrolic-N doped graphene microlattice aerogel

Haoyuan Yang,Hui Wang,Weidong Li,Bofang Tian,Tingting Xu,Dezhi Kong,Shaozhuan Huang,Kaikai Liu,Xinjian Li,Hui Ying Yang,Ye Wang,Kai-Kai Liu

DOI: https://doi.org/10.1039/d2ta03294e

IF: 11.9

2022-07-16

Journal of Materials Chemistry A

Abstract:Rechargeable sodium metal battery is a promising candidate for next-generation low-cost rechargeable batteries in virtue of broad and low cost of Na resources. However, safety issue caused by uncontrollable Na dendrite prevents its further development. Herein, we develop a three-dimensional (3D) printed nitrogen doped graphene aerogel (3DP-NGA) microlattice host to regulate a uniform Na nucleation and deposition. Density functional theory (DFT) calculation results indicate that the sodiophilic sites is mainly originated from pyrrolic-N defects, which can be easily created and controlled by plasma treatment. With designed architecture and N doping induced sodiophilic surface, 3DP-NGA microlattice can effectively guide the sodium ion flux and deposition, as well as decrease the nucleation energy barrier and provide abundant nucleation sites, leading to homogeneous deposition of Na without dendrite formation demonstrated by in-situ optical microscopy characterization. Encouragingly, the 3DP-NGA microlattice delivers low nucleation overpotentials (9.9 and 14.8 mV at 0.5 and 1.0 mA cm-2, respectively) and the ultralong cycle-life over 2000 h (3000 cycles) with an average Coulombic efficiency of 99.90% at a high current density of 3.0 mA cm-2 with 1.0 mAh cm-2. Moreover, a high Na loading of 10.0 mAh cm-2 (747.6 mAh g-1) electrode can cycle stably over 500 h. Finally, a 3D-printed full battery consisting of Na@3DP-NGA anode and 3D printed Na3V2(PO4)3C-rGO (3DP-NVP@C-rGO) cathode is assembled and delivers a capacity of 85.3 mAh g-1 at 100.0 mA g-1 after 1000 cycles.

materials science, multidisciplinary,chemistry, physical,energy & fuels