Abstract:As a major steel producer, China is now eager to develop feasible solutions to recycle and reuse steel slag. However, due to the relatively poor hydration activity of steel slag, the quantity of steel slag used as a supplemental binder material is limited. In order to improve the cementitious properties of steel slag, the strength and carbonation degree of the high-content steel slag powder–cement–metakaolin composite cementitious material system under CO2 curing conditions were investigated. The compressive strengths of the mortar specimens were tested and compared. The carbonation areas were identified and evaluated. A microscopic analysis was conducted using X-ray diffraction (XRD), thermogravimetry analysis (TG), and scanning electron microscopy (SEM) to reveal the chemical mechanisms. The results showed that CO2 curing significantly increased the early strength as the 3D compressive strength of the specimens increased by 47.2% after CO2 curing. The strength of the specimens increased with increasing amounts of metakaolin in a low water-to-binder ratio mixture. The 3D compressive strength of the specimens prepared with 15% metakaolin at a 0.2 water-to-binder ratio achieved 44.2 MPa after CO2 curing. Increasing the water-to-binder ratio from 0.2 to 0.5 and the metakaolin incorporation from 0% to 15% resulted in a 25.33% and 19.9% increase in the carbonation area, respectively. The calcium carbonate crystals that formed during carbonation filled the pores and reduced the porosity, thereby enhancing the strength of the mortar specimens. The soundness of the specimens after CO2 curing was qualified. The results obtained in the present study provide new insight for the improvement of the hydration reactivity and cementitious properties of steel slag powder.

Preparation of high flexural strength rankinite cement benefiting from formation of aragonite whisker during carbonation curing

Carbonation Curing of Industrial Solid Waste‐based Aerated Concretes

Sustainable Building Material from CO2 Mineralization Slag: Aggregate for Concretes and Effect of CO2 Curing

Enhanced Carbonation Curing of Cement Pastes with Dolomite Additive

Microstructure Refinement of Calcium-Sulfate-aluminate and Portland Cement (CSA-PC) Hybrids with Accelerated CO2 Curing (ACC)

Increasing flexural strength of CO<sub>2</sub> cured cement paste by CaCO<sub>3</sub> polymorph control

Preparation aragonite whisker-rich materials by wet carbonation of cement: Towards yielding micro-fiber reinforced cement and sequestrating CO2

Unlocking the Role of Recycled Aggregates in the Performance Enhancement and CO2 Capture of Reactive Magnesia Cement Formulations

The usage of rankinite for carbon capture and storage and carbonation kinetics

Influence of Mineral Admixtures on Carbonation Curing of Cement Paste

Hydration, carbonation and strength development of reactive MgO cement blended with lime (CaO) under different curing conditions

Effect of Carbonation Treatment on the Strength and CO2 Uptake Rate of Composite Cementitious Material with a High Steel Slag Powder Content

Effect of Carbonation Curing on Sulfate Resistance of Cement-Coal Gangue Paste

Instant CO2 curing for dry-mix pressed cement pastes: Consideration of CO2 concentrations coupled with further water curing

Carbonation curing of mortars produced with reactivated cementitious materials for CO2 sequestration

Strength formation mechanism and curing system optimization of low-carbon cementitious materials prepared by synergistic activation of multiple alkaline solid wastes

3D-printing of architected calcium silicate binders with enhanced and in-situ carbonation

The Influence of Mg-Impurities in Raw Materials on the Synthesis of Rankinite Clinker and the Strength of Mortar Hardening in CO2 Environment

Re-cementation Effects by Carbonation and the Pozzolanic Reaction on LWAs Produced by Hydrated Cement Paste Powder

Study On Effect Of Carbonation Curing For Cement Minerals And Clinker

Effect of rice husk ash on carbon sequestration, mechanical property and microstructure evolution of cement-based materials with early-age carbonation treatment