Abstract:Capacitively-Coupled Resistivity (CCR), Electrical Resistivity Tomography (ERT), and seismic surface wave testing using Love and Rayleigh waves were performed on Kinion Lake Dam, an embankment dam that has historically experienced significant seepage and internal erosion issues. The goal of this study is to detect seepage locations in the embankment dam for remediation purposes and map bedrock location across the area using nondestructive geophysical measurements. Surveys were completed along the crest and downstream toe of the dam to map subsurface conditions with a focus on seepage detection. The seismic surface wave data were analyzed using two different methods: Multichannel Analysis of Surface Waves (MASW) and Full Waveform Inversion (FWI). Both MASW and FWI methods were shown to be capable of resolving the bedrock layer below the dam, but the FWI method, provided a higher resolution image of the subsurface conditions compared to MASW method. However, the MASW and FWI provided little guidance regarding the seepage path through the dam. The CCR and ERT surveys, on the other hand, were shown to be very valuable for seepage detection. The seepage paths of the embankment dam were detected by comparing the resistivity measurements acquired in a wet winter and a dry summer. These seepage regions correspond well with previous sinkholes observed in the pool area following a drought. Additionally, new drilling in the two regions which showed differences in resistivity indicated the areas contained highly fractured limestone with evidence of solution cavities. It seems that the highly fractured limestone becomes fully saturated during the wet season causing very low resistivity values for these layers in wet seasons, but it quickly loses the water during the dry season leading to a highly resistive material in dry seasons. Therefore, seasonal resistivity measurements can be considered as a useful method for locating potential weak zones of earthen hydraulic structures in a cost-effective and timely manner.

Distortion of Resistivity Data Due to the 3D Geometry of Embankment Dams

3D effects on 2D resistivity monitoring in earth-fill dams

2D Inversion of DC Resistivity Method to Detect High-resistivity Targets inside Dams

Application of resistivity tomography technique to detecting hidden danger in embankment

Application of Resistivity Tomography Nondestructive Detection Technique to Earth-Rock Dam for Longfengshan Reservoir

Detection of Seepage Paths in Dam by Electrical Resistivity Tomography

Mapping Subsurface Conditions and Detecting Seepage Channels for an Embankment Dam Using Geophysical Methods: A Case Study of the Kinion Lake Dam

Geophysical investigation of earth dam using the electrical tomography resistivity technique

Seepage Detection in Earth-Filled Dam from Self-Potential and Electrical Resistivity Tomography

Validation of a new magnetometric survey for mapping 3D subsurface leakage paths

A new approach for accurate detection of leakage paths from multiple-wenner arrays inverted resistivity imaging in embankment dam

Monitoring of Älvkarleby test embankment dam using 3D electrical resistivity tomography for detection of internal defects

Characterization and Quantification of Dam Seepage Based on Resistivity and Geological Information

Integrated Geophysical Techniques in Detecting Hidden Dangers in River Embankments

Leakage detections for embankment dams based on high-density resistivity method

Joint Imaging of ERT Datasets and Its Application in Seepage Characterization at Nanshan Dam, Southeast China

Embankment dam leakage detection by joint use of Magnetic Resonance Sounding and Electrical Resistivity Imaging

An Iterative 3D Correction plus 2D Inversion Procedure to Remove 3D Effects from 2D ERT Data along Embankments

Anomaly Detection on Piezometer Data Collected from Embankment Dams Using Physical Model-Based Simulation

The Numerical Modeling Of Monitoring Of The Dam Leakage By Resistivity Imaging Technology

Numerical Simulation Of Waterproof Curtain Leakage Disease Of Soft Soil Foundation Pit Using Three-Dimension Resistivity Method