Surface modification of GO / PVDF composite membrane by MXene /protonated g‐C 3N4 nanosheets hybrids with improved dye separation and antifouling properties

Abdollah Ostovar,Mehdi Tarkhani,Seyyed Abbas Mousavi,Mahdieh Asadollahi
DOI: https://doi.org/10.1002/pen.26566
2024-01-03
Polymer Engineering & Science
Abstract:Abstract Graphene oxide‐polyvinylidene composite membranes were fabricated via the phase inversion technique. Then, GO‐PVDF membrane with highest water flux was achieved via surface modification with 2‐D MXene and 2‐D MXene /protonated 2‐D g‐C3N4 nanosheets hybrid via vacuum filtration of an aqueous dispersion of MXene and MXene‐protonated g‐C3N4 nanosheets hybrid, respectively, on GO‐PVDF membrane support to improve filtration efficiency and antifouling properties. The membranes were designated as MXene/GO‐PVDF (M 2 ) and MXene‐protonated g‐C3N4/GO‐PVDF(M 3 ). XRD, SEM, and FTIR analysis were used for characterization. The results showed that the performance of both MXene /GO‐PVDF and MXene‐ Pg‐C3N4/GO‐PVDF membranes was improved significantly in removing cationic dyes, unlike anionic pigments. Also, the resistance of these membranes against fouling has improved. The MXene‐ Pg‐C3N4/GO‐PVDF shows a significant enhancement in the removal of crystal violet (CV) cationic dye (100%) compared to the pristine membrane (84%) after 4 h of the filtration process. Tests also were performed to remove another two cationic dyes Methylene blue (MB), Rhodamine B (RB), and an anionic dye Methyl‐orange. The anionic dye separation rate from the stream did not show significant improvement while cationic dyes show significant enhancement in separation efficiencies. Modified membranes exhibit an enhancement of fouling resistance properties compared to pristine membranes. Highlights The water contact angle decreased from 71 to 45, which means hydrophilicity improved successfully. Membrane fouling resistance was improved around 15%–20%. PVDF membrane was prepared and graphene oxide was added to the matrix to modify the bulk properties. MXene and C 3 N 4 were synthesized successfully. Surface modification of the PVDF membrane was successful by MXene and C 3 N 4 .
engineering, chemical,polymer science
What problem does this paper attempt to address?