Abstract:Proper methods of surface fabrication and characterization are essential for various applications. For example, wickless heat pipes, such as flat plate pulsating heat pipes (FPPHP) and a compact flat thermosyphon (CFT), have massive potential for commercialization owing to simple construction, flexibility in using different working fluids, and better thermal contact with flat heat sources. In this work, various surface treatment methods such as chemical etching, electrochemical deposition, and laser texturing on a copper sample are investigated to prepare superhydrophilic or superhydrophobic surfaces, and the thermal durability of the as-prepared surfaces is tested through heating and boiling experiments for 15 days. The wettability modification methods are implemented on the surfaces of the FPPHP and CFT, with the different wettability combinations as either bare evaporator and condenser, completely superhydrophilic (that is, all surfaces including that of evaporator, condenser, and adiabatic section) or completely superhydrophobic or hydrophilic evaporator and superhydrophobic condenser. The thermal performance of the FPPHP and CFT subjected to different wettability combinations on the surface is investigated. Results of FPPHP are reported for water as the working fluid at 60 % filling ratio with power inputs given from 40-200 W. Similarly, for CFT, the results are reported for water filled at 50 % filling ratio with heat flux input from 2-20 W/cm 2 . On the FPPHP, the best thermal performance and lowest resistance were obtained when the entire surface was superhydrophilic with a maximum reduction of 60% at 200W. The CFT gives the best thermal performance with a bare evaporator and superhydrophobic condenser with a maximum decrease in thermal resistance of 42% at 20 W/cm 2 . The best-performing wettability combination for FPPHP and CFT is contrasting and has to be chosen appropriately depending on the heat transfer device.

Numerical model for evaluation of enhanced thermal performance of micro heat pipe with the wettability gradient surface by superhydrophobic/superhydrophilic VACNT nanocomposite

Performance of a Vertical Closed Pulsating Heat Pipe with Hydroxylated MWNTs Nanofluid

Heat Transfer Capacity Optimization Design of Microgroove and Microcolumn in an Ultra-Thin Flat Heat Pipe

Remarkable Thermal Performance Enhancement of Micro Heat Pipes with Graphene-Nanoplatelet Nano-Wicks

Experimental and theoretical investigation of the influence of heat transfer rate on the thermal performance of a multi-channel flat heat pipe

Numerical Study of the Thermal Performance of a Hydrogen Pulsating Heat Pipe

Surface Wettability Modifications and Applications in Wickless Heat Pipes

Thermal performance of flat plate heat pipe array with surface wettability modification: An experimental and simulation study

Comparison of nanofluid wetting characteristics in untreated and superhydrophilic microgrooved heat pipes

Ultra-efficient Heat Pipes Enabled by Nickel-Graphene Nanocomposite Coatings: Concept and Fundamentals

Study of the heat transfer performance of gravity heat pipes based on lattice Boltzmann surface modification

Numerical study flow and heat transfer characteristics of superhydrophobic single tube bundle surface and wake flow

Effects of using nanofluids on thermal performance and mass transfer in a micro-flat plate heat pipe

A Numerical and Experimental Study of Micro-Channel Heat Pipe Solar Photovoltaics Thermal System

Experimental investigation and multiparameter analysis of variable conductance heat pipes

Thermal Dynamics of Heat Pipes with Sub-Critical Nanopores

Numerical investigation of surface wettability effect on two-phase closed thermosyphon

Thermal Characterisation of Micro Flat Aluminium Heat Pipe Arrays by Varying Working Fluid and Inclination Angle

Effect of geometries on the heat transfer characteristics of flat-plate micro heat pipes

Numerical simulation of condensation heat transfer characteristics of R134a at high vapor velocity under different angles

A review of liquid metal high temperature heat pipes: Theoretical model, design, and application