Fabrication of the Oxygen Vacancy Amorphous MnO 2 /Carbon Nanotube as Cathode for Advanced Aqueous Zinc‐Ion Batteries

Hao Tong,Tingting Li,Jiang Liu,Daxiong Gong,Jinpan Xiao,Laifa Shen,Bing Ding,Xiaogang Zhang
DOI: https://doi.org/10.1002/ente.202000769
IF: 4.149
2020-12-16
Energy Technology
Abstract:<p>The serious limitations of MnO<sub>2</sub> are poor electrical conductivity and low utilization rate of electrochemical active area. These problems have seriously limited the application of MnO<sub>2</sub> aqueous zinc ion batteries (AZIB). Herein, by preparing MnO<sub>2</sub> uniformly loaded on the carbon nanotubes with good electrical conductivity can greatly improve the poor electrical conductivity of MnO<sub>2</sub>. Moreover, by introducing oxygen vacancy, the surface capacitance, the reaction kinetics and the electrochemical performance of MnO<sub>2</sub> can be obviously increased. The specific capacity of the <i>V</i><sub><i>o</i></sub>‐MnO<sub>2</sub>/CNT material is 314 mAh g<sup>‐1</sup>, at 0.2 A g<sup>‐1</sup>, and the capacity retention of 81% was achieved after 1000 cycles. In particular, the prepared device presents a distinct energy density of 416.2 Wh kg<sup>‐1</sup>. As a result, the capacity as well as the cycle stability is effectively improved compared with the original MnO<sub>2</sub>.</p><p>This article is protected by copyright. All rights reserved.</p>
energy & fuels
What problem does this paper attempt to address?