Abstract:The article describes the development of a modification of the Kolsky method used for testing brittle materials at splitting. The scheme of the experiment involves the application of a dynamic load along diametrically opposite generatrices of the cylindrical surface of the test specimen. At the same time, it is in a biaxial stressed state and fracture into two halves from the action of tensile stresses. The method is based on the assumption that the material under test behaves elastically under equilibrium deformation of the specimen. This modification is proposed to be used to determine the dynamic Young's modulus and Poisson's ratio. The derivation of relations for calculating the indicated mechanical characteristics based on Hooke's law using experimental possibilities is given. Approbation of the proposed scheme for determining elastic constants was carried out when testing specimens of fireclay brick in the Hopkinson split bar system. The deformation impulses of measuring bars were recorded with the help of tensometry to assess the forces acting on the sample and calculate the stresses arising in its center. Deformations of the central part of the specimen were determined using digital image correlation technology. The obtained graphs of stresses and strains versus time had a different time step using the optical method in combination with tensometry. The arrays of the obtained stress and strain values were reduced to a single and constant time interval up to the moment of specimen failure using linear interpolation to process the experimental data based on the derived formulas. The study made it possible to construct graphs of the dynamic Young's modulus and Poisson's ratio versus time at the initial stage of specimen loading and to determine the average values of these elastic mechanical characteristics.

Determination Of The Effective Dynamic Yield Strength Of Heterogeneous Materials

Identification of the Spallation Properties and Ultimate Spall Strength of Heterogeneous Materials in Dynamic Processes

Dynamic response for porous epoxy resin matrix composites filled with iron powder at different strain rates and constitutive relationships

Numerical Limit and Shakedown Analysis Method for Kinematic Hardening Structure Made of Arbitrary Inhomogeneous Material

Theoretical Statistical Solution and Numerical Simulation of Heterogeneous Brittle Materials

DETERMINATION OF THE DYNAMIC YOUNG'S MODULUS AND POISSON'S RATIO OF BRITTLE MATERIALS

Effect of non-uniform void distributions on the yielding of metals

A Virtual Laboratory Using High Resolution Crystal Plasticity Simulations to Determine the Initial Yield Surface for Sheet Metal Forming Operations

Monte Carlo simulation of complex cohesive fracture in random heterogeneous quasi-brittle materials

Effective toughness of heterogeneous materials with rate-dependent fracture energy

Theoretical Modeling of Temperature, Strain Rate and Porosity Dependent Yield Strength of Porous Metallic Material

A Yield Criterion for Porous Crystalline Materials with Inner Pressure

Effective toughness of heterogeneous brittle materials

On the superposition of strengthening mechanisms in dispersion strengthened alloys and metal-matrix nanocomposites: Considerations of stress and energy

Numerical Simulation of Elastic Behaviour and Failure Processes in Heterogeneous Material

Determination of the Mechanical Properties of Metals at Very High Strain Rates

Towards the Distribution of a Class of Polycrystalline Materials with an Equilibrium Defect Structure by Grain Diameters: Temperature Behavior of the Yield Strength

Numerical Simulation of Failure Process in Heterogeneous Elastoplastic Materials

A STUDY OF DYNAMIC MECHNICAL RESPONSE AND CONSTITUTIVE MODEL OF ENERGETIC MATERIALS

Analytical Solutions to the Constitutive Relations of Heterogeneous Brittle Materials

Yield criteria for quasibrittle and frictional materials