Abstract:This paper develops a one-dimensional simulation model of a thermoelectric module aiming at its characteristic exploration and output performance prediction. Almost all related effects are considered including Seebeck, Peltier, Thomson effects, the spatial- and temperature-dependent thermoelectric material properties, as well as the other irreversible factors. In order to ensure its high accuracy and computational efficiency, the differential equations built for components of non-linear physical properties, and analytical equations for the others of constant properties are jointly solved by numerical methods and implemented in MATLAB integrated development environment. A small deviation of 1.44% exists between its calculated output power and that by a previously reported three-dimensional model under a specific wide load range (0-250 Omega), validating its accuracy of this model. Besides, it indicates that both the proportions of heat leakage through the occupied air zone and its maximum output power to the input total heat flow have the same order of magnitude. A rising proportion for the former has to be paid attention in case of a higher temperature difference applied. The assumption of regarding its electrical contact resistance as an identical external resistance connected with the load in series is computationally proved to generate a negligible discrepancy in terms of TEM characteristics and its output performance. Furthermore, with respect to the impacts of TEM geometry, the pre-set fixed substrate area weakens the equivalence of regarding a thermoelectric module with larger cross-section area of thermoelectric legs as multiple identical modules with smaller leg areas connected in parallel. It accounts for the better linearity of rising output power by a long leg than that by a short leg as the leg area increases. A long thermoelectric leg means an increased induced electrical potential and inner resistance as well, thus leading to a single peak of the output power as the leg length increases. Finally, a thermoelectric geometric optimization approach abased on the Hill-climbing algorithm is introduced and first applied for the maximum output. Its accuracy and efficiency are validated and analyzed detailedly by supplying different variables as initial search point. All the methods and conclusions in this paper can assist thermoelectric generators' performance estimation and guide the geometric optimizations regarding their large-scale applications in the future.

Investigation of thermal radiation effects on thermoelectric module performance by an improved model

Numerical Modeling of the Performance of Thermoelectric Module with Polydimethylsiloxane Encapsulation

Numerical Modeling and Optimization of the Segmented PbTe–BiTe-based Thermoelectric Leg

Assessing the accuracy of mathematical models used in thermoelectric simulation: Thermal influence of insulated air zone and radiation heat

Influences of Thomson Effect and Additional Thermal Resistance on the Performance of Thermoelectric Module

Thermal Design and Management for Performance Optimization of Solar Thermoelectric Generator

Performance evolution of thermoelectric modules under constant heat flux

Effects of Temperature-Dependent Thermal Properties and the Side Leg Heat Dissipation on the Performance of the Thermoelectric Generator

The Practical Performance Forecast and Analysis of Thermoelectric Module from Macro to Micro

Comprehensive Modeling for Geometric Optimization of a Thermoelectric Generator Module

Effects of Thermal and Electrical Contact Resistances on the Performance of a Multi-Couple Thermoelectric Cooler with Non-Ideal Heat Dissipation

Numerical analysis of thermoelectric power generation coupled with temperature-dependent material properties

Designing thermoelectric self-cooling system for electronic devices: Experimental investigation and model validation

A three-dimensional model for thermoelectric generator and the influence of Peltier effect on the performance and heat transfer

Modeling of the Surface Temperature Field of A Thermoelectric Radiant Ceiling Panel System

Characteristics Analysis and Parametric Study of A Thermoelectric Generator by Considering Variable Material Properties and Heat Losses

Dimensional Analysis of Thermoelectric Modules under Constant Heat Flux

Modeling of Thermoelectric Generators with Effects of Side Surface Heat Convection and Temperature Dependence of Material Properties

Design a new thermoelectric module with high practicability based on experimental measurement

A Model to Evaluate the Device-Level Performance of Thermoelectric Cooler with Thomson Effect Considered

Numerical Simulations on the Temperature Gradient and Thermal Stress of a Thermoelectric Power Generator