Abstract:This article focuses on study of the microstructural and textural evolution, as well as the recrystallization kinetics under different cold‐rolling methods and their influencing mechanism on the properties of the thin‐gauge 3.5%Si nonoriented silicon steel, so as to obtain the best production process, that is, secondary cold rolling with an intermediate annealing temperature of 900 °C. The microstructural and textural evolution, as well as the recrystallization kinetics under different cold‐rolling methods and their influencing mechanism on the properties of the thin‐gauge 3.5%Si nonoriented silicon steel, are investigated by electron backscattering diffraction, X‐ray diffractometer, tensile, and magnetic properties test. The results indicate that compared with the primary cold‐rolling process, the reduction rate of secondary cold‐rolling process is lower (58.3%), and many shear bands are formed in the coarse cold‐rolled sheet, which leads to the formation of strong Goss and cube texture after recrystallization annealing. Owing to the high annealing temperature, the average grain size of finished annealed sheet is little different under different cold‐rolling processes, so the mechanical properties and high‐frequency iron loss are basically the same. The iron loss of the secondary cold‐rolled products decreases with an increase in frequency, and the improvement in the iron loss of the high field (1.5 T) becomes larger than that of the low field (1.0 T). Given the high anisotropy index of the Goss texture, the iron loss anisotropy of the secondary cold‐rolled sheet is higher. Considering the magnetic and mechanical properties, the optimum process is the secondary cold rolling with the intermediate annealing temperature of 900 °C.

Microstructure and Properties of 3.0% Si Steel Prepared by Twin-Roll Casting Process

Solidification structure and crystallographic texture of strip casting 3 wt.% Si non-oriented silicon steel

Microstructure, texture and magnetic properties of strip-cast 1.3% Si non-oriented electrical steels

Effect of Cold Rolling Process on Microstructure, Texture and Properties of Strip Cast Fe-2.6%Si Steel

Twin Roll Casting and Secondary Cooling of 6.0 wt.% Silicon Steel

Fabrication and properties of strip casting 4.5 wt% Si steel thin sheet

Microstructure and Texture Evolution of Strip-Cast and Hot-Rolled Fe-3 %si Steel Sheet

Microstructure and texture evolution of strip casting 3 wt% Si non-oriented silicon steel with columnar structure

Microstructure and texture evolution of ultra-thin grain-oriented silicon steel sheet fabricated using strip casting and three-stage cold rolling method

Ultra‐Thin 3.5%Si Steel with Both Magnetic Properties and Mechanical Properties Produced by Different Process Routes of Large‐Scale Production

Characterization of microstructure, texture and magnetic properties in twin-roll casting high silicon non-oriented electrical steel

Effect of Σ3 grain boundaries on microstructure and properties of oriented Fe-6.5 wt%Si in twin-roll strip casting

Experimental Study on the Twin Roll Strip Casting and Warm Rolling Fe-6.5 Wt. %si Steel Sheet

Effect of recrystallization annealing temperature on microstructure, texture and magnetic properties of non-oriented silicon steel produced by strip casting

Microstructure and texture evolution of thin-gauge non-oriented silicon steel with high permeability produced by twin-roll strip casting

Fabrication of Grain-Oriented Silicon Steel by a Novel Way: Strip Casting Process

Microstructural evolution and magnetic properties in strip cast non-oriented silicon steel produced by warm rolling

Hot Deformation Behavior of Free-Al 2.43 wt.% Si Electrical Steel Strip Produced by Twin-Roll Strip Casting and Its Effect on Microstructure and Texture

Microstructure Characteristics and Strengthening Behavior of Cu-Bearing Non-Oriented Silicon Steel: Conventional Process versus Strip Casting

Microstructure and Mechanical Property of Strip in Fe–23Mn–3Si–3Al TWIP Steel by Twin Roll Casting