Abstract:This study presents a computational fluid dynamics (CFD) based approach to determine the optimal positioning for an atmospheric turbulence sensor on a rotary-wing uncrewed aerial vehicle (UAV) with X8 configuration. The vertical (zBF) and horizontal (xBF) distances of the sensor to the UAV center to reduce the effect of the propeller-induced flow are investigated by CFD simulations based on the k−ε turbulence model and the actuator disc theory. To ensure a realistic geometric design of the simulations, the tilt angles of a test UAV in flight were measured by flying the drone along a fixed pattern at different constant ground speeds. Based on those measurement results, a corresponding geometry domain was generated for the CFD simulations. Specific emphasis was given to the mesh construction followed by a sensitivity study on the mesh resolution to find a compromise between acceptable simulation accuracy and available computational resources. The final CFD simulations (twelve in total) were performed for four inflow conditions (2.5 m s−1, 5 m s−1, 7.5 m s−1 and 10 m s−1) and three payload configurations (15 kg, 20 kg and 25 kg) of the UAV. The results depend on the inflows and show that the most efficient way to reduce the influence of the propeller-induced flow is mounting the sensor upwind, pointing along the incoming flow direction at xBF varying between 0.46 and 1.66 D, and under the mean plane of the rotors at zBF between 0.01 and 0.7 D. Finally, results are then applied to the possible real-case scenario of a Foxtech D130 carrying a CSAT3B ultrasonic anemometer, that aims to sample wind with mean flows higher than 5 m s−1. The authors propose xBF=1.7 m and zBF=20 cm below the mean rotor plane as a feasible compromise between propeller-induced flow reduction and safety. These results will be used to improve the design of a novel drone-based atmospheric turbulence measurement system, which aims to combine accurate wind and turbulence measurements by a research-grade ultrasonic anemometer with the high mobility and flexibility of UAVs as sensor carriers.

Real-time Wind Predictions for Safe Drone Flights in Toronto

Atmospheric flow simulation strategies to assess turbulent wind conditions for safe drone operations in urban environments

Identification of no-fly zones for delivery drone path planning in various urban wind environments

RPAS operations in urban airflow: Efficient modelling of representative wind speed variations along a flight path through a flow field with changing turbulence characteristics

Advances in CFD Modeling of Urban Wind Applied to Aerial Mobility

Near-surface wind profile test based on accuracy verification of UAV anemometer lifting height in an urban fringe built-up area

Improving the urban wind flow prediction efficiency of target area by considering its surrounding buildings impact

Estimating Omnidirectional Urban Vertical Wind Speed with Direction-Dependent Building Morphologies

WindSeer: Real-time volumetric wind prediction over complex terrain aboard a small UAV

Evaluating Reduced-Order Urban Wind Models for Simulating Flight Dynamics of Advanced Aerial Mobility Aircraft

Flow Structure around a Multicopter Drone: A Computational Fluid Dynamics Analysis for Sensor Placement Considerations

Synthetic Wind Estimation for Small Fixed-Wing Drones

Research on the Characteristics of Urban Building Cluster Wind Field Based on UAV Wind Measurement

A Computational Framework for the Simulation of Wind Effects on Buildings in a Cityscape

Machine-learned flow estimation with sparse data -- exemplified for the rooftop of a UAV vertiport

Low-altitude Sensing of Urban Atmospheric Turbulence with UAV

Operational wind and turbulence nowcasting capability for advanced air mobility

Autonomous navigation for low-altitude UAVs in urban areas

Two Supervised Machine Learning Approaches for Wind Velocity Estimation Using Multi-Rotor Copter Attitude Measurements

Visualization and Metrics Analysis of Wind Environments of Typical High-Rise Residential Building Cluster Configurations Using CFD and Image Processing.

Spatio-Temporal Wind Modeling for UAV Simulations