Abstract:The availability of multi-rotor UAVs with lifting capacities of several kilograms allows for a new paradigm in atmospheric measurement techniques, i.e., the integration of research-grade sonic anemometers for airborne turbulence measurements. With their ability to hover and move very slowly, this approach yields unrevealed flexibility compared to mast-based sonic anemometers for a wide range of boundary layer investigations that require an accurate characterization of the turbulent flow. For an optimized sensor placement, potential disturbances by the propeller-induced flow (PIF) must be considered. The PIF characterization can be done by CFD simulations, which, however, require validation. For this purpose, we conducted an experiment to map the PIF below a multi-rotor drone using a mobile array of five sonic anemometers. To achieve measurements in a controlled environment, the drone was mounted inside a hall at a 90° angle to its usual flying orientation, thus leading to the development of a horizontal downwash, which is not subject to a pronounced ground effect. The resulting dataset maps the PIF parallel to the rotor plane from two rotor diameters, beneath, to 10 D, and perpendicular to the rotor plane from the center line of the downwash to a distance of 3 D. This measurement strategy resulted in a detailed three-dimensional picture of the downwash below the drone in high spatial resolution. The experimental results show that the PIF quickly decreases with increasing distance from the centerline of the downwash in the direction perpendicular to the rotor plane. At a distance of 1 D from the centerline, the PIF reduced to less than 4 ms−1 within the first 5 D beneath the drone, and no conclusive disturbance was measured at 2 D out from the centerline. A PIF greater than 4 ms−1 was still observed along the center of the downwash at a distance of 10 D for both throttle settings tested (35% and 45%). Within the first 4 D under the rotor plane, flow convergence towards the center of the downwash was measured before changing to diverging, causing the downwash to expand. This coincides with the transition from the four individual downwash cores into a single one. The turbulent velocity fluctuations within the downwash were found to be largest towards the edges, where the shear between the PIF and the stagnant surrounding air is the largest.

RPAS operations in urban airflow: Efficient modelling of representative wind speed variations along a flight path through a flow field with changing turbulence characteristics

Atmospheric flow simulation strategies to assess turbulent wind conditions for safe drone operations in urban environments

Evaluating Reduced-Order Urban Wind Models for Simulating Flight Dynamics of Advanced Aerial Mobility Aircraft

Modeling advanced air mobility aircraft in data-driven reduced order realistic urban winds

Real-time Wind Predictions for Safe Drone Flights in Toronto

Advances in CFD Modeling of Urban Wind Applied to Aerial Mobility

Impact of urban canopy characteristics on turbulence dynamics: Insights from large eddy simulation

Turbulent flow modification in the atmospheric surface layer over a dense city

Near-surface wind profile test based on accuracy verification of UAV anemometer lifting height in an urban fringe built-up area

Modelling and Control of an Urban Air Mobility Vehicle Subject to Empirically-Developed Urban Airflow Disturbances

High-resolution wind speed measurements with quadcopter uncrewed aerial systems: calibration and verification in a wind tunnel with an active grid

Validation of wind measurements from a multirotor RPAS-mounted ultrasonic wind sensor using a ground-based LiDAR system

A Spatiotemporal Estimation Framework for Real-World LIDAR Wind Speed Measurements

Machine-learned flow estimation with sparse data -- exemplified for the rooftop of a UAV vertiport

Large Eddy Simulation of urban boundary layer flows using a canopy stress method

Rotary-wing drone-induced flow – comparison of simulations with lidar measurements

Low-altitude Sensing of Urban Atmospheric Turbulence with UAV

Application of a comprehensive atmospheric boundary layer model to a realistic urban-scale wind simulation

Flow Structure around a Multicopter Drone: A Computational Fluid Dynamics Analysis for Sensor Placement Considerations

Observation and Numerical Simulation of Cross-Mountain Airflow at the Hong Kong International Airport from Range Height Indicator Scans of Radar and LIDAR

Experimental Characterization of Propeller-Induced Flow (PIF) below a Multi-Rotor UAV