Thermo-hydraulic analysis in double-layered microchannels with porous rib and phase change microcapsules slurry as coolant

Chuntong Li,Wei Chen

DOI: https://doi.org/10.1016/j.icheatmasstransfer.2024.107489

IF: 6.782

2024-04-14

International Communications in Heat and Mass Transfer

Abstract:The porous ribs and solid ribs paved with porous layer (combining ribs for short) on sidewalls are set respectively in upper and lower channels in double-layered microchannel heat sink (MCHS) with microencapsulated phase change material (MPCM) slurry as coolant to obtain better thermal performance. In the cases, more heat transfer occurs between coolant and solid ribs with MPCM slurry as coolant due to phase change in microencapsulate, and larger specific area in porous layer. The local thermal equilibrium is considered to be in porous layer, and the Forchheimer-Brinkman-Darcy relations were used to describe the flow inside porous ribs. The effects of porous layer, its thickness in combining ribs, channel-to-pitch width ratio and channel aspect ratio on heat transfer and hydraulic properties in channel with MPCM slurry as coolant are investigated. Besides, the heat flux from heating surface released through the upper channel or lower channel to the outside can be allocated with the channel-to-pitch width ratio, width ratio of porous layer to pitch in the lower channel, and channel aspect ratio in double-layered microchannel. The parameter of figure of merit (FOM) is defined to evaluate thermo-hydraulic performance. Compared to the case with copper solid ribs in lower and upper channels as benchmark (i.e. FOM = 1), the 14% and 124.56% higher FOM value occur in the cases respectively of solid and porous ribs, and combining and porous ribs in lower and upper channels, as well as the 18.93% and 65.96% decreases respectively in thermal resistance and pumping power in case of MPCM slurry as coolant with combining and porous ribs in lower and upper channels. The appropriate width ratio of porous layer to pitch and porosity in porous layer will benefit thermal behavior.

thermodynamics,mechanics