Abstract:Effective corrosion inhibition of mild steel 1030 at 0.01 M NaCl concentration was achieved by the use of the nontoxic surfactant salt cetrimonium trans-4-hydroxy-cinnamate (CTA-4OHcinn). Polarization analysis on the steel samples immersed for 24 h in the control and CTA-4OHcinn-containing solutions shows the development of a passivation potential that is more obvious at higher inhibitor concentrations along with a maximum inhibition efficiency of 97.8%. Electrochemical impedance spectroscopy (EIS) pinpoints the effect of the inhibitor on the corroding regions of the metal surface, showing an increase in the local electric resistance and conversely a decrease in the local capacitance, which indicates that the charge transfer in the corroding regions is being hindered by a deposition process. This is consistent with scanning electron microscopy (SEM) images, showing the presence of a porous oxide matrix that fills localized corrosion sites on the metal surface after 24 h of immersion in a 0.01 M NaCl + 10 mM inhibitor solution. Additionally, SEM analysis also shows the formation of an organic film surrounding the defects that is able to shield chloride attack. As a result of diffusion of chloride from the defects below the protective film, filiform corrosion can be seen. Time-resolved impedance analysis over the first 120 min of immersion in the control and inhibitor solution shows that significant inhibitor protection does not take place immediately and there is a lag phase in the first 50 min of immersion, suggesting that early localized corrosion drives further adsorption of inhibitor micelles on the metal surface. This is in agreement with X-ray photoelectron spectroscopy (XPS) analysis, which indicates a complete surface coverage over the first 2 h of immersion in a concentrated inhibitor solution. XPS also shows the heterogeneity of the film, where some parts are poorly covered, revealing the underlying surface containing iron.

Variation in Synergy of Corrosion Inhibition, on Mild Steel in NaCl Solution, Due to Rare Earth: Ce, Y, La, Nd in Rare Earth Tartrates

Effect of organic component (tartrate) addition on cerium nitrate's ability to inhibit corrosion of mild steel in NaCl solution

Sustainable development of an effective anti-corrosion film over the St12-steel surface against seawater attacks using Ce(III) ions/tri-sodium phosphate anions

Dual function of rare earth carboxylate compounds on the barrier properties and active corrosion inhibition of epoxy coatings on mild steel

Rare Earth Cerium Increases the Corrosion Resistance of NdFeB Magnets

Electrochemical and Surface Characterization Study on the Corrosion Inhibition of Mild Steel 1030 by the Cationic Surfactant Cetrimonium Trans-4-hydroxy-cinnamate

Synergistic Protection of Mild Steel in Sodium Chloride Solutions Using Mixtures of Sustainable Corrosion Inhibitors

Sustainable Development of Corrosion Inhibitors from Electronic Scrap: Synthesis and Electrochemical Performance

Effect of rare earth composition on the electrochemical properties of multicomponent RENi5-xMx (M = Co, Mn, Ti) alloys

Rare Earth 2‐Methyl‐3‐furoate Complexes: Effect of Steric Hindrance on Corrosion Inhibitor Properties

Enhanced inhibition on hydrogen permeation during electrodeposition process by rare earth (RE = Ce) salt additive

Corrosion behavior and kinetics model of rare earth low‐alloy steel in a soil simulation solution

Rare earth cerium-phenanthroline binary complex as a new corrosion inhibitor for carbon steel in acidic medium

Self-healing performance of smart coatings modified with different corrosion inhibitors

Effect of CeAlO3 refractories on the cleanliness of rare earth treated steel

Efficacies of sodium nitrite and sodium citrate–zinc acetate mixture to inhibit steel rebar corrosion in simulated concrete interstitial solution contaminated with NaCl

Surface-modified cerium oxide as a corrosion inhibitor to enhance the performance of epoxy coatings

One-step preparation and characterization of a Ce-La-Y ternary rare earth conversion coating on magnesium alloy AZ91D

Study of effects of rare earth elements on the corrosion behavior of weathering steels under a simulated immersion environment and a real atmospheric environment

Investigation of rare earth (RE) on improving the corrosion resistance of Zr-Ti deoxidized low alloy steel in the simulated tropic marine atmospheric environment

Analysis of the Ce(III) chloride, Ce(III) nitrate, and Ce(III) propionate as corrosion inhibitor of the aluminum alloys in NaCl solution