Abstract:Due to the insulation fails caused by complex factors, such as the manufacture factors, transportation and complicated working environment, inter-turn short circuit fault is one of the frequent failures of shunt reactor, at the early stage of whom, its current is not high enough to trigger the protection equipment. However, the current in the shorted turn is very high, which causes serious copper loss, resulting in high temperature rise. In severe case, it will cause fire accident and explosion. Thus, it’s important to design a sensitive and reliable method to detect the inter-turn short circuit fault at its early stage. In this paper, a method based on the power loss factor (PLF) considering both the activate power and equivalent resistance of reactor, is proposed to detect the inter-turn short circuit fault of an air-core shunt reactor considering the effect of insulation resistance. Taking a BKDCL−20000/35 dry-type air-core shunt reactor as an example, the inter-turn short circuit faults occur at different axial heights and coil layers are investigated. The electrical parameters, including equivalent resistance, equivalent inductance, active power, reactive power etc. are presented and comparison is implemented between the normal condition and failure conditions. The current and active power of the shorted turn is calculated and analyzed, which are used to explain the parameters variation of the reactor when inter-turn short circuit fault occurs. Finally, PLF under various working conditions is computed and presented, which provide an alternative to monitor the inter-turn short circuit fault.

A Novel Fault Leakage Current Detection Method With Protection Deadzone Elimination

Principle of leakage current protection based on residual current variation and its application

Single-phase-to-ground Fault Detection with Distributed Parameters Analysis in Non-Direct Grounded Systems

A Novel Multi-Functional Leakage Current Protector IC Design

An Innovative Method to Achieve Minimum Tripping Current Conformity for Type A RCCBs

Design of a Type B Residual Current Device for Fault Leakage Current Detection

Cloud-Based Non-Intrusive Leakage Current Detection for Residential Appliances

A Novel Method for Current Transformer Saturation Countermeasure Based on Comparing Two Currents' Polarities

Household Distribution Protection Device with Fault Pre-Detecting

Development of a New Type of Leakage Current Protection Device for Distribution Network

A Novel Selective Earth Fault Detection Method Using Residual Current

A Novel Method for Small Current Ground Fault Line Detection and Implementation Using Neural Network

Design and Realization of Power Equipment Current-carrying Faults Intelligent Warning System

Research on AC and DC leakage detection technology based on fluxgate principle

A novel current amplitude differential protection for active distribution network considering the source-effect of IM-type unmeasurable load branches

The Influence of Line Impedance on Leakage Current Detection in Low Voltage DC Systems

A novel method to determine leakage inductance for internal fault analysis in power transformer

A New Method to Detect the Short Circuit Current in DC Supply System Based on the Flexible Rogowski Coil

Residual Current Detection Method Based on Variational Modal Decomposition and Dynamic Fuzzy Neural Network

Study onFault Location Method Based on Leakage Energy Function

A New Method to Detect the Inter-Turn Short Circuit Fault of Dry-Type Air-Core Shunt Reactor