Abstract:Impact direction is one of the critical factors affecting the waterdrop erosion behavior of materials. In this paper, rain erosion damage behavior of a typical carbon fiber reinforced polymer (CFRP) laminate is investigated as a function of the impingement angle (0° as normal impact and 15°, 30°, 45° as oblique impact deviated from the normal) and the relative fiber orientation (parallel PA and perpendicular PE to the fiber direction of the surface layer) under the waterjet velocity of 320 m/s and the impact frequency of 50 Hz via a pulsating waterjet erosion test rig. After continuous impact of multiple waterjets, the typical damage of CFRP laminates is mainly composed of the central erosion crater and the upheaval of the surrounding surface layer. The onset and evolution of damage are mainly driven by the shear action of lateral jetting and stress concentration of hydraulic penetration exerted at the surface irregularities. There is no significant difference in the damage modes between the normal and oblique impacts, except for the asymmetric distributions of matrix cracking in PA-orientation and delamination in PE-orientation caused by the angle inclination. With the impingement angle increasing, the volume loss and erosion depth decrease while the incubation period increases mainly due to the decreases of water hammer pressure and contact area. The PA-orientation can cause lower incubation period and larger erosion mass loss than PE-orientation before the surface ply is penetrated, with the underlying mechanism related to the distinct tensile properties of CFRP laminates along longitudinal and transversal directions and the asymmetric properties of fiber–matrix interface. According to the fitting results of erosion curves, it is possible to describe the incubation period and the erosion rate of CFRP laminates under oblique impact using a two-branch equation, and Springer model can give reasonable prediction for the average incubation period and PA-orientation erosion rate of a certain oblique impact occasion with known 0° impact erosion results.

On the damage behavior of poly(methyl methacrylate) impacted by high-velocity water jet

Damage behavior and assessment of aeronautical PMMA subjected to high-velocity water-jet impact

Strain-rate-dependent Cohesive Zone Modelling of Charge Damage Behavior when a Projectile Penetrates Multilayered Targets

Deformation and Damage Mechanisms of Laminated Glass Windows Subjected to High Velocity Soft Impact

Elastic/plastic Impact Simulation of Water Jet Using Smoothed Particle Hydrodynamics and Finite Element Method

Soft Impact Response of Laminated Glass Plates

Numerical Simulation of Material Surface Damage by High Speed Liquid-Solid Impact

Numerical and Experimental Study on Mechanism of Material Damage by High Speed Liquid-solid Impact

Research on Surface Damage of Solid Material Subjected to High Speed Liquid Impact

Research on Flow Field Characteristics in Water Jet Nozzle and Surface Damage Caused by Target Impact

Investigation of the Mechanical Behaviors and Damage Mechanism of C/C Composites Impacted by High-Velocity Jets

Comparative study on the water droplet erosion behavior between stretched and casted aeronautical PMMA

Smoothed Particle Hydrodynamics Modeling of Thermal Barrier Coating Removal Process Using Abrasive Water Jet Technique

Damage evolution of CFRP laminates by normal and oblique impact erosion of pulsating water jets

Surface removal of ductile metal using cyclic low-frequency impact of a discrete particle-less waterjet

Damage evolutions and failure mechanism of reinforced concrete impacted by abrasive water jet

Mechanical response and damage mechanism of C/SiC composites impacted by high-velocity water jet

Experimental and numerical study of water-filled vessel impacted by flat projectiles

Fracturing mechanism and crack expansion rule of concrete impacted by high pressure water jet

Numerical study on the damage of liquid-filled containers subjected to shaped charge jet impact

A novel quantitative analysis approach for hole surface damage of ceramic matrix composites machined by abrasive waterjet