Abstract:Powered ankle-foot prostheses can often reduce the energy cost of walking by assisting with push-off. However, focus on providing mechanical work may lead to ignoring or exacerbating common issues with chronic pain, irritation, pressure ulcer development, and eventual osteoarthritis in persons with amputation. This paper presents the design and validation of a novel transtibial prosthesis informed by predictive biomechanical simulations of gait which minimize a combination of user effort and interaction loading from the prosthesis socket. From these findings, the device was designed with a non-biomimetic anterior-posterior translation degree of freedom with a 10 cm range of motion which is primarily position-controlled to change the alignment of the prosthetic foot with the residual limb. The system is both mobile and tethered, with the batteries, actuators, and majority of electronics located in a small backpack. Mechanical loads are transmitted through cables to the prosthesis, minimizing the distal mass carriage required. We measured torque and force sensing accuracy, open loop actuator performance, closed loop torque and position control bandwidth, and torque and position tracking error during walking. The system is capable of producing up to 160 N-m of plantarflexion torque and 394 N of AP translation force with a closed loop control bandwidth of about 7 Hz in both degrees of freedom. Torque tracking during walking was accurate within about 10 N-m but position tracking was substantially affected by phase lag, possibly due to cable slack in the bidirectional mechanism. The prototype was capable of replicating our simulated prosthesis dynamics during gait and offers useful insights into the advantages and the practical considerations of using predictive biomechanical simulation as a design tool for wearable robots.

A Multiaxial Bionic Ankle Based on Series Elastic Actuation With a Parallel Spring

Design of a Flexible Bionic Ankle Prosthesis Based on Subject-specific Modeling of the Human Musculoskeletal System

Ankle Foot Motion Recognition Based on Wireless Wearable Semg and Acceleration Sensors for Smart AFO

Sprinting Motion Planning for Planar Bipedal Robots Based on Driving Coordination between the Knee and Ankle Joints

Intelligent ankle–foot prosthesis based on human structure and motion bionics

DEVELOPMENT OF BIOMIMETIC POWERED ANKLE-FOOT PROSTHESIS WITH COMPLIANT JOINTS AND SEGMENTED FOOT

A Sagittal Planar Ankle-Foot Prosthesis with Powered Plantarflexion and Socket Alignment

Design and Preliminary Results of a Reaction Force Series Elastic Actuator for Bionic Knee and Ankle Prostheses

PANTOE 1: Biomechanical Design of Powered Ankle-Foot Prosthesis with Compliant Joints and Segmented Foot

The Study of Ankle Assisted Exoskeleton

Design and Performance Evaluation of a Novel Wearable Parallel Mechanism for Ankle Rehabilitation

Power to the springs: Passive elements are sufficient to drive push-off in human walking

Design and Analysis of the Bionic Mechanical Foot with High Trafficability on Sand

C-JAE: 3 DOF Robotic Ankle Exoskeleton with Compatible Joint Axes

ANKLE ACTUATION FOR THREE-DIMENSIONAL LIMIT CYCLE WALKERS IN LATERAL BALANCE

Design, Characterization, and Preliminary Assessment of a Two-Degree-of-Freedom Powered Ankle-Foot Prosthesis

A bionic mechanical foot with adaptive variable postures travelling on sand

Passive dynamic walking with flat feet and ankle compliance

MLP Based Continuous Gait Recognition of a Powered Ankle Prosthesis with Serial Elastic Actuator

Design and Experimental Research of 3-RRS Parallel Ankle Rehabilitation Robot

Integrated and Lightweight Design of Electro-hydraulic Ankle Prosthesis