Abstract:Chemical looping reforming (CLR) with biomass pyrolysis oil (BPO) for syngas production was investigated using NiO/dolomite as the bed material which was prepared by the wet impregnation method. The NiO/dolomite was used as catalyst and oxygen carrier in the whole temperature range, while it was also acted as in-situ CO2 sorbent at 600 °C and 700 °C. The syngas production was dominated by the sorption enhanced and catalytic reforming of BPO, due to the formation of NiO–MgO solid solution, which had a lower reducibility at low temperatures. Although, the low level CGE at low temperature could be improved by elevating the oxygen coefficient at the certain extent, poor cyclic performance of NiO/dolomite at 700 °C was observed, owning to the sintering and agglomeration during the repeated carbonation/calcination reactions. High temperatures inhibited the carbonation reaction and facilitated the reduction of NiO–MgO solid solution to provide more lattice oxygen and catalytic active sites. The syngas production was governed by the synergistic effect of lattice oxygen and catalysis at high temperatures. The optimum operating condition for syngas production in CLR was obtained by the analysis showed as follows: the temperature at 900 °C with ϕ = 0.4 in fuel reactor. The corresponding values of cold gas efficiency (CGE), syngas yield (Ysyn) and syngas purity (Psyn) were 80.76%, 1.318 Nm3/kg and 92.06%, respectively. Besides that, the NiO/dolomite exhibited a good cycle performance under this condition. The CGE and Ysyn decreased slightly to 76.26% and 1.265 Nm3/kg after 10 cycles, respectively. Overall, NiO/dolomite is a promising multifunctional material in the CLR process with BPO for syngas production. More attention should be paid to improve the mechanical strength of NiO/dolomite in the future.

Performance of NiAl 2 O 4 spinel derived catalyst + dolomite in the sorption enhanced steam reforming (SESR) of raw bio-oil in cyclic operation

Sorption-Enhanced Steam Reforming of Glycerol for Hydrogen Production over a NiO/NiAl2O4 Catalyst and Li2ZrO3-Based Sorbent

The ReSER-COG Process for Hydrogen Production on a Ni–CaO/Al2O3 Complex Catalyst

Preparation of a Mesoporous Sorption Complex Catalyst and Its Evaluation in Reactive Sorption Enhanced Reforming

Stability of the Ni–TiO2@nano CaO/Al2O3 Complex Catalyst Used in ReSER Process for Hydrogen Production

Influence of CoAl2O4 spinel and Co-phyllosilicate structures derived from Co/sepiolite catalysts on steam reforming of bio-oil for hydrogen production

Global Vision of the Reaction and Deactivation Routes in the Ethanol Steam Reforming on a Catalyst Derived from a Ni-Al Spinel

Multifunctional Pd/Ni-Co catalyst for hydrogen production by chemical looping coupled with steam reforming of acetic acid

Hydrogen Production from Sorption-Enhanced Steam Reforming of Phenol over a Ni–Ca–Al–O Bifunctional Catalyst

Steam Reforming of Model Bio-Oil Aqueous Fraction Using Ni-(Cu, Co, Cr)/SBA-15 Catalysts

Syngas production via chemical looping reforming biomass pyrolysis oil using NiO/dolomite as oxygen carrier, catalyst or sorbent

Improving Coking Resistance and Catalytic Performance of Ni Catalyst from LaNiO3 Perovskite by Dispersion on SBA-15 Mesoporous Silica for Hydrogen Production by Steam Reforming of Ethanol

Sustainable carbon-based nickel catalysts for the steam reforming of model compounds of pyrolysis liquids

Hydrogen Production from Steam Reforming of Biomass-Derived Levulinic Acid over Highly Stable Spinel-Supported Ni Catalysts

A novel high-entropy spinel ferrites (CoNiCuZnMg)Fe 2 O 4 catalyst for H 2 production via steam reforming of derived volatiles from polypropylene and waste cooking oil

Comparison of the regenerability of Co/sepiolite and Co/Al2O3 catalysts containing the spinel phase in simulated bio-oil steam reforming

Effects of Preparation Method on the Performance of Ni/Al 2 O 3 Catalysts for Hydrogen Production by Bio-Oil Steam Reforming

Steam reforming of ethanol over Ni/MgAl2O4 catalysts

Biogas dry reforming over Li–Ni–Al LDH-derived catalysts

Sorption-enhanced Steam Reforming of Toluene Using Multifunctional Perovskite Phase Transition Sorbents in a Chemical Looping Scheme

Alkali metal bifunctional catalyst-sorbents enabled biomass pyrolysis for enhanced hydrogen production