Abstract:The critical micelle concentration (CMC) is an important parameter of widely used surfactants and needs to be measured in the application and development of surfactants. Fluorometric method is a widely used method determining CMC values owing to the advantages of highly sensitivity, fast response and wide application range. There are two common methods (I and II) of preparing samples for CMC fluorometric determination. In the process of developing CMC probes with aggregation-induced emission (AIE) characteristics, we found that methods I and II were not suitable for CMC probes with AIE charateristics and developed a new sample preparation method (III), which is not only suitable for CMC probes with AIE characteristic but also decreases operation procedures and errors owing to omitting the addition of micro amount of dyes into each sample. To ascertain if method III is also suitable for other CMC probes without AIE characteristics, the CMC values of surfactants were determined by fluorometric method using widely used pyrene without AIE charateristic as probe and methods I–III to prepare samples. The obtained experimental results proved that method III not only was suitable for preparation of samples for CMC determination of surfactants using pyrene as probe but also led to the least average deviation (methods I–III led to ±0.13, ±0.34 and ±0.05 mM deviation for the CMC determination of sodium dodecyl sulfate (SDS), respectively). The CMC determination using pyrene as probe is based on its change in the ratio ( I FIII / I FI ) of its emission peaks I and III with surfactant concentration. Unexpectedly, it was found that the I FIII / I FI value of pyrene in surfactant solutions is sensitive to the measurement conditions changing exciting light energy, such as slit widths and sample-measured number. In addition, it was found that surfactant SDS or cetrimonium bromide from different suppliers not only has significantly different CMC values but also leads to very different I FIII / I FI values of pyrene in a certain concentration of surfactant, which can be used as a simple method to distinguish the same surfactant with different CMC values.

Dual emissive amphiphilic carbon dots as ratiometric fluorescent probes for the determination of critical micelle concentration of surfactants

Determination of Critical Micelle Concentration (CMC) of Surfactants Using Environmentally Sensitive Carbonized Polymer Dots

Detection of the critical micelle concentration of cationic and anionic surfactants based on aggregation-induced emission property of hexaphenylsilole derivatives

Carbon Quantum Dots as Fluorescent Probes in the Measurement of the Critical Micelle Concentration of Surfactants

Critical micelle concentration determination of sodium dodecyl sulfate by fluorescence spectrometry without fluorescent probe

Influence factors on the critical micelle concentration determination using pyrene as a probe and a simple method of preparing samples

Determination of Critical Micellar Aggregation Numbers of Quaternary Ammonium Gemini Surfactants Containing Modified Rosin by Steady-State Fluorescence Probe Method

Multi-functional ratiometric detection based on dual-emitting N-doped carbon dots

Ratiometric Sensing of Azithromycin and Sulfide Using Dual Emissive Carbon Dots: A Turn On-Off-On Approach

Full-color-emitting fluids from carbon dots stabilized in nonconventionally fluorescent micelles

A novel amidine-based fluorescent probe TPE-4 + for rapid detection of anionic surfactant sodium dodecyl sulfate

Flow-injection chemiluminescence method for determination of critical micelle concentration of surfactants

A surfactant type fluorescence probe for detecting micellar growth.

Ratiometric fluorescent probe based on dual-emissive carbon dots for determination of silver ions

Dual-emission Carbon Dots Achieved by Luminescence Center Modulation Within One-Pot Synthesis for a Fluorescent Ratiometric Probe of Ph, Hg 2+ , and Glutathione

The environmental-sensitivity of a fluorescent ZTRS-Cd(ii) complex was applied to discriminate different types of surfactants and determine their CMC values.

Disassembly-driven Colorimetric and Fluorescent Sensor for Anionic Surfactants in Water Based on a Conjugated Polyelectrolyte/dye Complex

An induction current method for determining the critical micelle concentration and the polarity of surfactants

Mechanism study of Dual-Emission ratiometric fluorescent pH-Sensitive carbon quantum dots and its application on mornitoring enzymatic catalysis

A dual-mode fluorescent probe based on carbon dots for detecting solution polarity

Facile synthesis of red dual-emissive carbon dots for ratiometric fluorescence sensing and cellular imaging