Abstract:Accessories such as joints and terminations represent weak points in HVDC cable systems. The DC field distribution is intimately dependent on the thermal conditions of the accessory and on material properties. Moreover, there is no available method to probe charge distribution in these conditions. In this work, the field distribution in non-stationary conditions, both thermally and electrically, is computed considering crosslinked polyethylene (XLPE) as cable insulation and different insulating materials (silicone, rubber, XLPE) for a 200 kV joint assembled in a same geometry. In the conditions used, i.e., temperatures up to 70 °C, and with the material properties considered, the dielectric time constant appears of the same order or longer than the thermal one and is of several hours. This indicates that both physical phenomena need to be considered for modelling the electric field distribution. Both the radial and the tangential field distributions are analysed, and focus is given on the field distribution under the stress cone on the ground side and near the central deflector on the high voltage side of the joint. We show that the position of the maximum field varies in time in a way that is not easy to anticipate. Under the cone, the smallest tangential field is obtained with the joint insulating material having the highest electrical conductivity. This results from a shift of the field towards the cable insulation in which the geometrical features produce a weaker axial component of the field. At the level of the central deflector, it is clear that the tangential field is higher when the mismatch between the conductivity of the two insulations is larger. In addition, the field grows as a function of time under stress. This work shows the need of precise data on materials conductivity and the need of probing field distribution in 3D.

Recent technologies of joints for HV and EHV XLPE cables in Japan

DC Electric Field Optimization of AC XLPE Cable Joint in DC Operation

Electrical and Physico-chemical Properties of XLPE under Different Vulcanization Pressures for 500 Kv EHVDC Cable Factory Joint

Investigation on Dielectric Insulation Properties of ±525 Kv HVDC XLPE Material for High Temperatures Applications

Effect of Tensile Stress on Insulation Properties of 500 Kv EHVAC XLPE Cable under Multi-Field Ageing

Electrical Insulation Performance of Cross‐linked Polyethylene/mgo Nanocomposite Material for ±320 Kv High‐voltage Direct‐current Cables

Numerical Analysis of Thermo-Electric Field for AC XLPE Cables with Different Service Times in DC Operation Based on Conduction Current Measurement

Investigation on Thermal Aging and Degradation of XLPE for High Voltage Cable Applications

Analysis of Thermo-electric Coupled Simulation for 10 Kv AC XLPE Cable under Different DC Topologies and Laying Modes

Numerical Analysis of Thermo-Electric Field for AC XLPE Cable in DC Operation Based on Conduction Current Measurement.

Numerical analysis of thermo-electric field for 10 kV AC XLPE cable in DC operation

Test methods and results for recent outdoor insulation in Japan

Electric Field Distribution in HVDC Cable Joint in Non-Stationary Conditions

Research Status of HVDC XLPE Cable

Research on Defects of High Voltage Cable Fusion Joint Using XLPE Insulation Material

Experimental research on partial discharge localization in XLPE cable accessories using multi sensor joint detection technology

The Insulation of HVDC Extruded Cable System Joints. Part 1: Review of Materials, Design and Testing Procedures

On-line monitoring techniques for 110 kV and above XLPE cable

The Relationship Between Partial Discharge Behavior and the Degradation of 10 Kv Xlpe Cable Joints

Two-dimensional Space Charge Measurement in Cable Joint Model Using the Pulsed Electroacoustic Method

Investigation of space charge behavior of HVDC XLPE cables using PEA method