Abstract:Numerous adsorbents have been applied for Heavy Metals (HMs) removal from contaminated water. The aim of this review was to critically analyze the status of research in HMs detection and adsorption, focusing on the adsorption approaches for better defining the corresponding future challenges and their potential solutions. Present research demonstrates the promising outlook for using remote sensing technology in the preliminary selection of contaminated areas before final HMs detection using spectrometry, microwave or electrochemical sensors. Adsorption can then be applied in treating HMs contaminated water due to its high effectiveness and low-cost. Natural zeolites showed 90 %-100 % Pb2+, 2 + , 95 % Cd2+ 2 + and 100 % Cu2+ 2 + removal from water, their effectiveness is affected by initial pH, and adsorbent dosage and size. As synthesized zeolites, zeolitized pumice waste showed 100-500 mg/g of HMs adsorption at pH 4.0-5.0, 57 mg/g Zn2+ 2 + by oxalate-loaded zeolites and 682 mg/g Pb2+ 2 + and 122 mg/g Ni2+ 2 + by zeolite nanoparticle impregnated polysulfone membrane from wastewater. Activated carbon exhibited 99 %-100 % Hg2+, 2 + , 93 % Cu2+ 2 + and 99 % Co2+ 2 + removal from water under acidic environment. Biochar is more ecofriendly and demonstrated its effectiveness in removing up to 98 % Cd2+, 2 + , 97 % Cu2+, 2 + , 99 % Pb and 94 % Zn2+ 2 + from water. Chitosan showed 755 mg/g Pb2+, 2 + , 979 mg/g Cd2+ 2 + and 877 mg/g Cu2+ 2 + removal at pH 2.0-6.0 from wastewater. Peat moss exhibited 96 % Cu2+ 2 + and 50 % Cr6+ 6 + removal from wastewater at lower pH. Similarly, bioremoval showed 143 mg/g Zn2+ 2 + (algae) adsorption at pH 6.0 in, and 90 % Cr6+ 6 + and 98 % Cu2+ 2 + removal by biomass ash. Recently, carbon, magnetic and titanium nanotubes/composites have shown high efficiency and selectivity in HMs removal, but their preparation is often more expensive than their counterparts. In addition, adding enhancement solutions promoted HMs adsorption and reduced treatment time. Chemical precipitation demonstrated feasibility to recycle and recover extracted HMs and spent adsorbent. This review demonstrates the need for highly selective and efficient adsorbent, and guides the future researchers to make funtionalized and organic-inorganic composite HMs adsorbents.

Advances in green materials derived from wood for detecting and removing mercury ions in water

Utilizing adsorption of wood and its derivatives as an emerging strategy for the treatment of heavy metal-contaminated wastewater

Effective Removal of Mercury Ions in Aqueous Solutions: A Review

Remediation of Mercury Contaminated Soil, Water, and Air: A Review of Emerging Materials and Innovative Technologies

Removal of Hg(ii) in Aqueous Solutions Through Physical and Chemical Adsorption Principles

Heavy Metals Detection and Removal from Contaminated Water: A Critical Review of Adsorption Methods

Current status of advancement in remediation technologies for the toxic metal mercury in the environment: A critical review

Post-synthetic modification on metal organic frameworks composite for efficient removal and sensitive detection of mercury ions in water

Chitosan-Based Polymer Nanocomposites for Environmental Remediation of Mercury Pollution

A new technology for the treatment of mercury contaminated water and soils

Activated sawdust as a sustainable solution for mercury removal in contaminated waters

Application of biomass adsorbents in the treatment of heavy metals in wastewater: a review

Efficient mercury ion abatement through highly porous cellulose nanofibrils combined with microporous organic polymer enhancements

Cellulose-based adsorbent using in mercury detection and removal from water via an efficient grafting strategy of fluorometric sensors by click reaction

Efficient removal of mercury ions with MoS2-nanosheet-decorated PVDF composite adsorption membrane

Bis-Schiff base cellulosic nanocrystals for Hg (II) removal from aqueous solution with high adsorptive capacity and sensitive fluorescent response

Construction of cellulose-based hybrid hydrogel beads containing carbon dots and their high performance in the adsorption and detection of mercury ions in water

Xylan-based ratiometric fluorescence carbon dots composite with delignified wood for highly efficient water purification and photothermal conversion

Selective adsorption of mercury ion from water by a novel functionalized magnetic Ti based metal-organic framework composite

A selective colorimetric and efficient removal strategy for mercury (II) in aquatic system using mesoporous Fe3O4-loaded silver probes

Research progresses on adsorption of mercury with silica gel composite material