Abstract:To optimise the benefits of the deep-rolling process in the service life context of treated components, the process application must be investigated. In addition to the reduction in surface roughness and near-surface material strengthening, compressive residual stresses are introduced, which are primarily responsible for the increase in service life for components, especially in the case of high-strength steel materials. A numerical parameter sensitivity analysis is performed in order to investigate the introduced residual stresses in detail. For this purpose, a validated deep-rolling simulation model is used, which replicates the deep rolling of a railway axle made of the high-strength steel material 34CrNiMo6. The model is based on an elastic-plastic Chaboche material model parameterised on uniaxial tensile and LCF test results and validated with residual stress measurements. Using this model as a basis, the effect of the main process parameters deep-rolling force, feed rate, friction coefficient, number of overruns, tool geometry, and shaft geometry on the resulting residual stress state are investigated. The results reveal that the deep-rolling force has the most significant influence on the introduced residual stress state and should therefore be highlighted. In the case of applying a deep-rolling force of more than 10 kN, maximum compressive residual stresses of around − 1000 MPa are introduced, and a strong saturating behaviour is shown. Maximum compensating tensile residual stresses of + 100 MPa occur below the surface. The main influence of the deep-rolling force is the effective depth achieved, which is determined by the depth of the zero crossing. This varies from 1 mm with an applied force of 2 kN to more than 3.5 mm with 20 kN. Furthermore, the results are analysed to conclude suggestions for the process's applicability, and a proposal for an optimised deep-rolling treatment is presented. There multiple deep rolling with decreased deep-rolling forces is used to achieve a comparably optimised residual stress state. In summary, with the presented results, a contribution to a deeper understanding of the deep-rolling process can be achieved; the influence of the most important process parameters on the residual stress in-depth profiles is established; an optimisation proposal is presented; and correlations are found. Thus, the base work for further fatigue strength assessments and the optimisation of the deep-rolling process regarding the increase of service is laid.

Dynamic compensation of the threading speed drop in rolling processes

Elongation Control of the Ultra-Thin Tinplate During Two-Stand Temper Rolling Unsteady Process

Adaptive Pass Scheduling for Roughness Control in Cold Rolling

Research on Dynamic Response of Cold Rolling Mill with Dynamic Stiffness Compensation

Coupling of an analytical rolling model and reinforcement learning to design pass schedules: towards properties controlled hot rolling

The development of time-dependent compensation model for roller CVC profile generation in precision grinding

Advanced feeding strategy driven by staged growth velocity for groove-section profiled ring rolling

Research on roll contour and control strategy for edge drop control of high-strength steel in the cold rolling precision mill

Integrated AGC Approach for Balancing the Thickness Dynamic Response and Shape Condition of a Hot Strip Rolling Control System

An online intelligent method for roller path design in conventional spinning

Analysis of friction fluctuations mechanism of a preloaded roller linear motion guide based on a new 5-DOF dynamic stiffness model

Nash equilibrium-based distributed predictive control strategy for thickness and tension control on tandem cold rolling system

Modeling of Deep Rolling as a Distortion Compensation Strategy during Profile Grinding

Coupled Vertical–Horizontal Vibration Characteristics of a Cold Rolling Mill Based on an Optimized Karman Differential Equation

A review of static and dynamic analysis of ball screw feed drives, recirculating linear guideway, and ball screw

Numerical parameter sensitivity analysis of residual stresses induced by deep rolling for a 34CrNiMo6 steel railway axle

An improved method for calculating roll deformation of six-high rolling mill: enhances computation speed and accuracy

Process Variable Optimization for Hot-Profiled Rolling of SAE 52100 Steel

Study on the dynamic characteristics of planetary gear transmission mechanism of metal cold rolling mill

An innovative spinning-rolling process and its intelligent FE modelling for big-tapered profiled ring disk

Replicating the rolling-sliding dynamics of cam-roller contacts in large-scale hydraulic drivetrains: A small-scale approach