Abstract:In this paper, the fretting wear behaviour of steel wires working in coal mining technology is studied numerically. In past studies, the fretting process of steel wires was carried out numerically considering that the coefficient of friction (COF) and wear coefficient (WC) are constant parameters. However, it has been noticed experimentally that COF increases up to a certain number of fretting cycles and then becomes constant, i.e. a steady-state stage, depending on the loading conditions. This increase in COF during the fretting process is also known as the running-up stage. The fretting wear model is modified to evaluate the influence of the varying coefficient of friction (VCOF), which is associated with the variable wear coefficient (VWC), so the influence of VWC is also considered. The subroutine UMESHMOTION used to implement the wear law is also modified to study the effect of VCOF and VWC. Therefore, in this study, the numerical results of a three-dimensional finite element (FE) model are compared, with analytical results of contact area and contact stresses, and with experimental results of peak wear depth. After validating the FE model, the wear scar, the increasing wear depth, wear volume, and the decreasing contact stress with increasing fretting cycles are determined numerically considering VCOF and VWC using cycle jump approach. The energy dissipation effect of frictional force and fretting amplitude is also studied for varying interaction properties of fretting wear models. The numerical simulations are performed by considering both elastic and plastic material properties to analyse the influence of varying interaction properties on fretting wear models at the running-up stage. The results indicate that the VWC model exhibits comparable impacts on both the elastic and plastic models. The results also show that the VWC fretting wear model leads to higher wear scar, wear volume, and wear depth values at the running-up stage as well as at the steady state stage, which are close to the experimental data.

Wear transitions in a wear coefficient model

A parameter-free mechanistic model of the adhesive wear process of rough surfaces in sliding contact

Investigation on the causes of rail corrugation in high-speed railways based on the wheel–rail transient rolling contact model and wear model

Comparison of wheel/rail contact modelling in prediction of wheel tread wear under changeable friction conditions

Mathematical Modeling of the Wear Rate of the Friction Pair of a Locomotive Wheel–Rail

Wear-rate transitions and their relationship to wear mechanisms

Numerical tribology of the wheel-rail contact : Application to corrugation defect

Peridynamic modeling of rail wear during sliding contact considering thermal effects

Wear of a crossing under dynamic wheel impact

Finite element analysis of fretting wear considering variable coefficient of friction

Wheel-rail contact wear analysis on curved lubricated track for heavy haul locomotive studies

Long-term evolution mechanism of the rail weld irregularity in metro lines based on the wear theory

A wheel wear prediction model of non-Hertzian wheel-rail contact considering wheelset yaw: Comparison between simulated and field test results

Wear prediction for metals

Investigation of the wear curves of the railway wheel and rail profiles when changing the radii of curvature

A numerical study on locomotive wheel wear on curved track subjected to adhesion control

Simulation of fretting wear in steel wires under variable coefficient of friction and variable wear coefficient

Determination of Creep Force, Moment, and Work Distribution in Rolling Contact With Slip

Predicting railway wheel wear by calibrating existing wear models: Principle and application

A study of wheel wear on a high-speed railway motor car

The Friction and Wear Model of Steels and Their Probable Statistic Calculations