Abstract:The prepared catalysts consisted of REY zeolite (15 wt.-%) and kaolin clay. The preparation was performed by hydrothermal hot pressing (HHP) at different temperatures, and the catalytic cracking and physicochemical properties of these samples have been investigated intensively. The catalytic conversion and selectivity for gasoline in the pentadecane and heavy oil cracking on these samples treated by HHP at different temperatures (25–220°C) varied significantly, in contrast to those on the sample without HHP treatment. In particular, the catalyst treated at 170°C exhibited high catalytic activity and selectivity for gasoline, low coke formation, and high compressive strength. These results suggest that HHP may be important for preparing cracking catalysts with high catalytic conversion and low price as a new route. X-ray diffraction (XRD) studies showed that the REY zeolite in the catalysts was stable during the HHP at temperature from 25 to 170°C, and increasing the temperature to 220°C resulted in partial destruction of REY zeolite crystalline. Characterization of physicochemical properties showed that the density, compressive strength, and the most probable pore diameter of the various samples increased with the HHP temperature. The surface area of various samples basically remained the same at the HHP temperature of 25–170°C, and the surface area decreased remarkably by increasing the HHP temperature to 220°C. IR spectra of pyridine adsorbed on these showed that there were both Brønsted and Lewis acid sites, and the TPD-NH3 studies indicated that the acid strength increased. The relative difference in the catalytic performance for cracking reactions is discussed, and is assigned to the following possible factors: (A) the variation in the acid types such as Brønsted and Lewis sites, acid concentration, and acid strength; (B) the destruction of REY zeolite crystallites; (C) the change in some physicochemical properties.

Hydrothermal treatment of natural rectorite enhanced Mo sulfidation for slurry-phase hydrocracking of vacuum residue

Hydrocracking of vacuum residue in a slurry phase reactor: effect of reaction temperature and properties of feedstock

Study on the Sulfurization of Molybdate Catalysts for Slurry-Bed Hydroprocessing of Residuum

A novel preparation strategy for an oil-soluble catalyst in slurry phase hydrocracking: Synergistic effect and electronic regulation of Fe on MoS 2

Atomic coordination structural dynamic evolution of single-atom Mo catalyst for promoting H2 activation in slurry phase hydrocracking

Study on the Effect of Catalyst Properties on Residue Hydroconversion

Upcycling of Cr-Containing Sulfate Waste into Efficient FeCrO3/Fe2O3 Catalysts for CO2 Hydrogenation Reaction

Hydrodechlorination of tetrachloroethylene over sulfided catalysts: kinetic study

Cleaner recycling of spent Ni–Mo/γ-Al2O3 catalyst based on mineral phase reconstruction

Catalytic Cracking Activity and Physicochemical Properties of REY Zeolite Mixed with Kaolin Clay Treated by Hydrothermal Hot Pressing Method

Synergism Between Hydrogen Donors and Dispersed Catalysts in Hydrocracking of Residue

Regeneration of the Slurry-Phase Hydroconversion Catalyst Precursor

Influence of catalysts on the hydrothermal liquefaction of municipal primary sludge: Upgrading to a higher quality biocrude

Post-Steam-Treatment of Mo/Hzsm-5 Catalysts: an Alternative and Effective Approach for Enhancing Their Catalytic Performances of Methane Dehydroaromatization

Hydrothermal Liquefaction Biocrude Stabilization via Hydrotreatment

Rhenium modification on NiMo/Al2O3 catalyst and effects on the hydrodesulfurization reaction route selectivity of 4,6-dimethyldibenzothiophene

Microwave Sodium Roasting (MWSR) Spent HDS Catalysts for Recovery Mo and in Situ Sulfur Fixation

Catalytic hydrothermal liquefaction of sewage sludge: Effect of metal support heterogeneous catalysts on products distribution

In Situ Treatment by High-Temperature Water Vapor As a Novel Health-Care Approach for Commercial SCR Catalyst

Residue Upgrading in Slurry Phase over Ultra-fine NiMo/gamma-Al2O3 Catalyst

Effect of Residual Cuts on Deactivation of Hierarchical Y Zeolite-Based Catalysts during Co-Processing of Vacuum Gas Oil (VGO) with Atmospheric Residue (ATR)