Abstract:Short-wave infrared (SWIR) spectroscopy has recently emerged as an important technology across a wide range of areas, whether industrial, biomedical, or environmental. Nevertheless, it is still a long-standing challenge to develop robust SWIR light sources. The SWIR phosphor-convert light emitting diodes (LEDs) by coating blue LED chips with desirable SWIR-emitting phosphors are becoming an ideal alternative for solid-state SWIR light sources due to its compactness, low-cost, and long operating lifetime, as does the commercial white LEDs. Herein, we report a blue-pumped Cr3+-doped LiScGeO4 SWIR phosphor as a luminescent converter for phosphor-convert SWIR LEDs. This phosphor shows an intense SWIR emission band with a peak wavelength at ∼1120 nm owing to the 4T2 → 4A2 electron transition of Cr3+ when exciting with blue light. The full width at half-maximum (fwhm) of the phosphor is ∼300 nm and the absolute quantum efficiency is determined to be ∼26%. SWIR LED prototypes are constructed by combining the optimized phosphor materials with commercial blue InGaN LED chips, which can generate a commendable emission band in the SWIR region over 800–1600 nm and achieve a maximum output power of ∼4.78 mW at 60 mA with the photoconversion efficiency of 4.4%. The current exploration of Cr3+-doped SWIR-emitting phosphors will lay the foundation to engineer phosphor-convert SWIR LEDs for applications in night-vision surveillance and SWIR spectroscopy technology. These blue-light-excitable SWIR-emitting phosphors can serve as an important complement to the spectral gap of the current Cr3+-doped phosphors in the SWIR region and will pave the way toward cost-effective phosphor-converted solid-state SWIR light sources.The Supporting Information is available free of charge at https://pubs.acs.org/doi/10.1021/acsami.1c10490.Calculated lattice parameters for LiScGeO4:Cr3+ phosphor, output power values, absorption spectra, excitation and emission spectra at 77 K, the relationships of lg(x) versus lg(I/x), the fwhm values LiScGeO4:1%Cr3+ phosphor under different temperature, the plot of ln[(I0/I)−1] versus 1/kT, excitation line of BaSO4 and emission spectrum of the selected LiScGeO4:1%Cr3+ phosphor using an integrating sphere, and electroluminescence spectrum of the fabricated SWIR-LED device for photoelectric efficiency measurement (PDF)This article has not yet been cited by other publications.

Tunable Luminescence in LiSc1‐yGayW2O8:Cr3+ Phosphors for LED Applications

Realize short-wave infrared luminescence in NaScP2O7:Cr3+,Yb3+ phosphor: Spectral and energy transfer

Distorted octahedral site occupation-induced high-efficiency broadband near-infrared emission in LiScGe2O6:Cr3+ phosphor

A single luminescence center ultra-broadband near-infrared LiScGeO4:Cr phosphor for biological tissue penetration

Ultra-broadband near-infrared phosphor Li3Sc2(PO4)3:Cr3+ realized by two-sites occupation

An Ultra Broadband NIR Phosphor LiScSnO4:Cr3+ with Emission Wavelength Peaking at 900 Nm for Component Analysis

Luminescence properties and phase transformation of broadband NIR emitting A2(WO4)3:Cr3+ (A=Al3+, Sc3+) phosphors toward NIR spectroscopy applications

A novel efficient broadband near-infrared phosphor LiGaGe2O6:Cr3+ with EQE enhancement and spectral tuning by Sc3+-Ga3+ substitution for NIR pc-LED application

Achieving Ultra-Wideband NIR-II Emission in Cr 3+ -Doped Li(Sc,In)(Si,Ge)O 4 Phosphors Based on Host Composition Engineering

La3Sc2Ga3O12:Cr3+, Nd3+ Near-Infrared Phosphor for Nondestructive Detection and Luminescence Thermometry

Highly Efficient Near-Infrared Solid Solution Phosphors with Excellent Thermal Stability and Tunable Spectra for Pc-Led Light Sources Toward NIR Spectroscopy Applications.

Design of broadband near-infrared Y<sub>0.57</sub>La<sub>0.72</sub>Sc<sub>2.71</sub>(BO<sub>3</sub>)<sub>4 </sub>:Cr<SUP>3+</SUP> phosphors based on one-site occupation and their application in NIR light-emitting diodes

Tunable broadband near-infrared luminescence from Cr3+-doped gallium oxide-based phosphors for advanced sensing and LED applications

Photoluminescence Properties of AScSi2O6:Cr3+ (A = Na and Li) Phosphors with High Efficiency and Thermal Stability for Near-Infrared Phosphor-Converted Light-Emitting Diode Light Sources.

Broadband Short-Wave Infrared Light-Emitting Diodes Based on Cr 3+ -Doped LiScGeO 4 Phosphor

Enhancement of Near‐Infrared Phosphor Luminescence Properties via Construction of Stable and Compact Energy Transfer Paths

Broadband near‐infrared (NIR) emitting Cr3+‐doped La3Ga5SnO14 phosphor with long persistent and photostimulated persistent luminescence

Spectrally tunable and thermally stable near-infrared luminescence in Na 3 Sc 2 (PO 4 ) 3 :Cr 3+ phosphors by Ga 3+ co-doping for light-emitting diodes

Achieving a tunable and ultra-broadband near-infrared emission in the Ga2-2 xZnxGexO3:Cr3+ phosphor

Interstitial Li+ Occupancy Enabling Radiative/Nonradiative Transition Control Toward Highly Efficient Cr3+-Based Near-Infrared Luminescence.