Abstract:Carbon fiber reinforced polyether-ether-ketone (CF/PEEK) composite materials had a wide range of applications in the aerospace, electronics and electrical fields, etc. The composite materials were generally prepared from prepregs. Commonly used prepreg tape preparation methods had disadvantages of uneven resin distribution and inadequate fiber impregnation, resulting in high porosity and poor mechanical properties. In this research, a combined process of the double powder impregnation method and the melt homogenization method was used to prepare the CF/PEEK prepreg tape to solve the previous problems. Using this method, the porosity of the prepreg tape was reduced by 56.30 % and the tensile strength was increased by 43.35 % compared with the traditional powder impregnation method. At the same time, the prepreg tape was widened and thinned and the uniformity of resin distribution was improved. Besides, based on the single factor experiment, the response surface method was used to construct the impregnation model of the quadratic polynomial regression equation between the process parameters (powder impregnation temperature, traction speed and melt homogenization temperature) and the porosity of the CF/PEEK prepreg tape. According to this model, the process parameters for the porosity of the prepreg tape were calculated to reach the minimum, namely, the powder impregnation temperature was 380 °C, the traction speed was 1 m/min, and the melt homogenization temperature was 380 °C. As a result of these process parameters, the porosity of the prepreg tape could be reduced to 7.39 %. Subsequently, the model was verified through experiments, which could provide a reference for the process parameters setting of the impregnation process.

Influence and optimization of parameters of prepreg viscosity during placement

Analysis and Characterization of Interlaminar Tack for Different Prepreg Materials During Automated Fiber Placement

Modeling and experimental validation of compaction pressure distribution for automated fiber placement

Compaction Pressure Distribution and Pressure Uniformity of Segmented Rollers for Automated Fiber Placement

Process-dependent Wrinkle Formation for Steered Tow During Automated Fiber Placement: Modeling and Experimental Verification

Cohesive zone model for prepreg tack based on probe test

An Analytical Model for Pressure Distribution in Automated Fiber Placement on Irregular Surfaces and Its Application in Aeronautical Manufacturing

Influence of Process Parameters on the Interlaminar Shear Strength of CF/PEEK Composites In-Situ Consolidated by Laser-Assisted Automated Fiber Placement

Determination of lubricating behavior of resin during the sliding process of unidirectional prepreg

Study on Processing Parameters of Tape Placement for Continuous GF Reinforced PP Laminates

Hot-press bonding mechanism and mechanism designing for prepreg

Interply friction of carbon fiber/epoxy prepreg stacks under different processing conditions

Pressure Distribution for Automated Fiber Placement and Design Optimization of Compaction Rollers

Study on impregnation parameters in preparation of CFF/PEEK laminates

Experiments and Viscoelastic Analysis of Peel Test with Patterned Strips for Applications to Transfer Printing

Characterization of Inter-Ply Slipping Behaviors in Hot Diaphragm Preforming: Experiments and Modelling

The effects of processing parameters on the wedge peel strength of CF/PEEK laminates manufactured using a laser tape placement process

Deformation and Fracture Mechanisms of Automated Fiber Placement Pre-Preg Laminates under Out-of-plane Tensile Loading

Inter-Ply Slipping Behaviors and Kinetic Equation of Carbon Fiber-Reinforced Epoxy Prepregs for Hot Diaphragm Preforming

Numerical and experimental study of the viscosity and mechanical parameters effect on tow feeding quality during automated fiber placement

Optimization of Powder Impregnation Process Parameters of Carbon Fiber Reinforced Polyether-ether-ketone Prepreg Tape by Response Surface Methodology